tda4865j NXP Semiconductors, tda4865j Datasheet - Page 15

• Manufacturer Part Number: tda4865j
• Description: Eflection Boosters For Use In Vertical Deflection Systems For Frame Frequencies Up To 200 Hz.
• Manufacturer: NXP Semiconductors

NXP Semiconductors
14. Soldering
TDA4865J_TDA4865AJ_2
Product data sheet
14.1 Introduction to soldering through-hole mount packages
14.2 Soldering by dipping or by solder wave
14.3 Manual soldering
14.4 Package related soldering information
This text gives a brief insight to wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Table 10.
[1]
[2]
Package
CPGA, HCPGA
DBS, DIP, HDIP, RDBS, SDIP, SIL
PMFP
For SDIP packages, the longitudinal axis must be parallel to the transport direction of the printed-circuit
board.
For PMFP packages hot bar soldering or manual soldering is suitable.
[2]
Suitability of through-hole mount IC packages for dipping and wave soldering
Rev. 02 — 3 November 2006
TDA4865J; TDA4865AJ
Soldering method
Dipping
-
suitable
-
Vertical deflection booster
Wave
suitable
suitable
not suitable
stg(max)
© NXP B.V. 2006. All rights reserved.
[1]
). If the
15 of 18