tda5145ts-c1 NXP Semiconductors, tda5145ts-c1 Datasheet - Page 12

• Manufacturer Part Number: tda5145ts-c1
• Description: Brushless Dc Motor Drive Circuit
• Manufacturer: NXP Semiconductors

Philips Semiconductors
T
Capacitor CAP-TI is used for timing the successive steps
within one commutation period; these steps include some
internal delays.
The most important function is the watchdog time in which
the motor EMF has to recover from a negative diode pulse
back to a positive EMF voltage (or vice versa). A watchdog
timer is a guarding function that only becomes active when
the expected event does not occur within a predetermined
time.
The EMF usually recovers within a short time if the motor
is running normally (<<ms). However, if the motor is
motionless or rotating in the reverse direction, then the
time can be longer (>>ms).
A watchdog time must be chosen so that it is long enough
for a motor without EMF (still) and eddy currents that may
stretch the voltage in a motor winding; however, it must be
short enough to detect reverse rotation. If the watchdog
time is made too long, then the motor may run in the wrong
direction (with little torque).
1998 Oct 27
handbook, full pagewidth
HE TIMING CAPACITOR
Brushless DC motor drive circuit
Fig.8 CAP-CD and CAP-DC typical voltage waveforms in normal running mode.
(CAP-TI)
on CAP-CD
on CAP-DC
voltage
voltage
12
The capacitor is charged with a current of 57 A, from
0.2 to 0.3 V. Above this level it is charged with a current of
5 A, up to 2.2 V only if the selected motor EMF remains
in the wrong polarity (watchdog function). At the end, or, if
the motor voltage becomes positive, the capacitor is
discharged with a current of 28 A. The watchdog time is
the time taken to charge the capacitor with a current of
5 A, from 0.3 to 2.2 V.
To ensure that the internal delays are covered CAP-TI
must have a minimum value of 2 nF. For the watchdog
function a value of 10 nF for CAP-TI is recommended.
To ensure a good start-up and commutation, care must be
taken that no oscillations occur at the trailing edge of the
flyback pulse. Snubber networks at the outputs should be
critically damped.
Typical voltage waveforms are illustrated in Fig.9.
MGH317
t
TDA5145TS
Product specification