tja1054 NXP Semiconductors, tja1054 Datasheet - Page 22

• Manufacturer Part Number: tja1054
• Description: Fault-tolerant Can Transceiver
• Manufacturer: NXP Semiconductors

Philips Semiconductors
REVISION HISTORY
DATA SHEET STATUS
Notes
1. Please consult the most recently issued data sheet before initiating or completing a design.
2. The product status of the device(s) described in this data sheet may have changed since this data sheet was
3. For data sheets describing multiple type numbers, the highest-level product status determines the data sheet status.
2004 Mar 23
3
2
LEVEL
I
II
III
Fault-tolerant CAN transceiver
REV
published. The latest information is available on the Internet at URL http://www.semiconductors.philips.com.
Objective data
Preliminary data Qualification
Product data
20040323
20011120
DATA SHEET
STATUS
DATE
(1)
200310013C
Development
Production
STATUS
PRODUCT
CPCN
(2)(3)
Product specification (9397 750 11721)
Modification:
Product specification (9397 750 08965)
This data sheet contains data from the objective specification for product
development. Philips Semiconductors reserves the right to change the
specification in any manner without notice.
This data sheet contains data from the preliminary specification.
Supplementary data will be published at a later date. Philips
Semiconductors reserves the right to change the specification without
notice, in order to improve the design and supply the best possible
product.
This data sheet contains data from the product specification. Philips
Semiconductors reserves the right to make changes at any time in order
to improve the design, manufacturing and supply. Relevant changes will
be communicated via a Customer Product/Process Change Notification
(CPCN).
Add V
wake-up event at transceiver pins RXD and ERR.
Mode control diagram, Fig.3, completed.
Recommendation added, to connect a not used pin WAKE to pin BAT.
Reference of bond pad coordinates changed from the bottom left-hand
corner of the die, to the bottom left-hand corner of the top aluminium
layer.
Change of bare die dimension.
Add Chapter REVISION HISTORY.
BAT
= 5.3 V to 27 V condition for correct signalling of local or remote
22
DESCRIPTION
DEFINITION
Product specification
TJA1054