lu82562ex Intel Corporation, lu82562ex Datasheet - Page 13

• Manufacturer Part Number: lu82562ex
• Description: Dual Footprint
• Manufacturer: Intel Corporation

2.2.2
Table 4. CSA Port CI_RCOMP Resistor Values
Figure 3. CSA port CI_RCOMP Circuits
CSA Port Resistive Compensation
The values of R1, R2 and R3 must be rated at ±1% tolerance. The selected resistor values must also
ensure that the reference voltage and reference swing voltage tolerance are maintained over the
input leakage specification. A 0.1 µF capacitor (C1 in
to each resistor divider, and a 0.01 µF bypass capacitor (C2 in
0.25 inches of reference voltage pins. If the length of the trace from the voltage divider to the pin is
greater than 1 inch, place more than one 0.01 µF capacitor near the reference voltage pin. The trace
length from the voltage divider circuit to the CI_REF pins must be no longer than 3.5 inches.
Both the voltage reference and voltage swing reference signals should be routed at least 10mils
wide and spaced at least 20 mils from all other signals.
The CSA port uses a resistive compensation signal (CI_RCOMP) to compensate buffer
characteristics for temperature, voltage, and process.
Intel
Component
®
82547GI(EI)
Trace Impedance
60 Ω ± 15%
82547GI(EI)
Intel®
82562EZ(EX)/82547GI(EI) Dual Footprint Design Guide
CI_RCOMP
RCOMP Resistor Value
R1 = 30.1 Ω ± 1%
Figure
1.2V
R1
2) should be placed within 0.5 inches
Figure
2) should be placed within
RCOMP Resistor Tied To
VCC1.2
5