uda1334ats NXP Semiconductors, uda1334ats Datasheet - Page 19

• Manufacturer Part Number: uda1334ats
• Description: Low Power Audio Dac With Pll
• Manufacturer: NXP Semiconductors

Philips Semiconductors
17.5
Notes
1. All surface mount (SMD) packages are moisture sensitive. Depending upon the moisture content, the maximum
2. These packages are not suitable for wave soldering as a solder joint between the printed-circuit board and heatsink
3. If wave soldering is considered, then the package must be placed at a 45 angle to the solder wave direction.
4. Wave soldering is only suitable for LQFP, TQFP and QFP packages with a pitch (e) equal to or larger than 0.8 mm;
5. Wave soldering is only suitable for SSOP and TSSOP packages with a pitch (e) equal to or larger than 0.65 mm; it is
2000 Jul 31
BGA, LFBGA, SQFP, TFBGA
HBCC, HLQFP, HSQFP, HSOP, HTQFP, HTSSOP, SMS
PLCC
LQFP, QFP, TQFP
SSOP, TSSOP, VSO
Low power audio DAC with PLL
temperature (with respect to time) and body size of the package, there is a risk that internal or external package
cracks may occur due to vaporization of the moisture in them (the so called popcorn effect). For details, refer to the
Drypack information in the “Data Handbook IC26; Integrated Circuit Packages; Section: Packing Methods” .
(at bottom version) can not be achieved, and as solder may stick to the heatsink (on top version).
The package footprint must incorporate solder thieves downstream and at the side corners.
it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.
definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.
(3)
Suitability of surface mount IC packages for wave and reflow soldering methods
, SO, SOJ
PACKAGE
19
not suitable
not suitable
suitable
not recommended
not recommended
WAVE
(2)
SOLDERING METHOD
(3)(4)
(5)
suitable
suitable
suitable
suitable
suitable
UDA1334ATS
Product specification
REFLOW
(1)