pcf8566 NXP Semiconductors, pcf8566 Datasheet - Page 16

• Manufacturer Part Number: pcf8566
• Description: Universal Lcd Driver For Low Multiplex Rates
• Manufacturer: NXP Semiconductors

Philips Semiconductors
6.16
This selects one of the four bits per display RAM address
for transfer to the display latch. The actual bit chosen
depends on the particular LCD drive mode in operation
and on the instant in the multiplex sequence. In 1 : 4
multiplex, all RAM addresses of bit 0 are the first to be
selected, these are followed by the contents of bit 1, bit 2
and then bit 3. Similarly in 1 : 3 multiplex, bits 0, 1 and 2
are selected sequentially. In 1 : 2 multiplex, bits 0 then 1
are selected and, in the static mode, bit 0 is selected.
The PCF8566 includes a RAM bank switching feature in
the static and 1 : 2 multiplex drive modes. In the static
drive mode, the BANK SELECT command may request
the contents of bit 2 to be selected for display instead of
bit 0 contents. In the 1 : 2 drive mode, the contents of
bits 2 and 3 may be selected instead of bits 0 and 1.
This gives the provision for preparing display information
in an alternative bank and to be able to switch to it once it
is assembled.
6.17
The input bank selector loads display data into the display
RAM according to the selected LCD drive configuration.
Display data can be loaded in bit 2 in static drive mode or
in bits 2 and 3 in 1 : 2 drive mode by using the BANK
SELECT command. The input bank selector functions
independently of the output bank selector.
Table 4 Blinking frequencies
1998 May 04
BLINKING MODE
Universal LCD driver for low multiplex
rates
Output bank selector
Input bank selector
0.5 Hz
2 Hz
1 Hz
Off
NORMAL OPERATING
MODE RATIO
f
f
f
CLK
CLK
CLK
/184320
/368640
/92160
POWER-SAVING
MODE RATIO
f
f
f
CLK
CLK
CLK
16
/15360
/30720
/61440
6.18
The display blinking capabilities of the PCF8566 are very
versatile. The whole display can be blinked at frequencies
selected by the BLINK command. The blinking frequencies
are integer multiples of the clock frequency; the ratios
between the clock and blinking frequencies depend on the
mode in which the device is operating, as shown in
Table 4.
An additional feature is for an arbitrary selection of LCD
segments to be blinked. This applies to the static and 1 : 2
LCD drive modes and can be implemented without any
communication overheads. By means of the output bank
selector, the displayed RAM banks are exchanged with
alternate RAM banks at the blinking frequency. This mode
can also be specified by the BLINK command.
In the 1 : 3 and 1 : 4 multiplex modes, where no alternate
RAM bank is available, groups of LCD segments can be
blinked by selectively changing the display RAM data at
fixed time intervals.
If the entire display is to be blinked at a frequency other
than the nominal blinking frequency, this can be effectively
performed by resetting and setting the display enable bit E
at the required rate using the MODE SET command.
Blinker
NOMINAL BLINKING FREQUENCY
blinking off
f
blink
0.5
2
1
Product specification
(Hz)
PCF8566