ics650-40 Integrated Device Technology, ics650-40 Datasheet - Page 3

no-image

ics650-40

Manufacturer Part Number
ics650-40
Description
Ethernet Switch Clock Source
Manufacturer
Integrated Device Technology
Datasheet
External Components
Recommended Operation Conditions
IDT™ / ICS™ ETHERNET SWITCH CLOCK SOURCE
Absolute Maximum Ratings
ICS650-40
ETHERNET SWITCH CLOCK SOURCE
A minimum number of external components are required for proper operation. Decoupling capacitors of 0.01 F
should be connected between VDD and GND pairs. The capacitors should be placed between pins VDD and GND,
and VDDO and GND, as close to the device as possible. A 33 series terminating resistor should be used on each
clock output if the trace is longer than 1 inch. A 25 MHz fundamental mode parallel resonant crystal should be used
with C
On chip capacitors. On Chip capacitors are used for a 18 pF load crystal. Small 2 to 3 pf trimming capacitors are
used from pins X1 to ground and X2 to ground to optimize the initial accuracy.
Stresses above the ratings listed below can cause permanent damage to the ICS650-40. These ratings, which are
standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these
or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
L
=18 pF.
Parameter
Ambient Operating Temperature
Power Supply Voltage (measured in respect to GND)
Supply Voltage, VDD
All Inputs and Outputs
Ambient Operating Temperature
Storage Temperature
Junction Temperature
Soldering Temperature
Item
3
+3.15
Min.
0
7 V
-0.5 V to VDD+0.5 V
0 to +70 C
-65 to +150 C
125 C
260 C
Typ.
Rating
ICS650-40
CLOCK SYNTHESIZER
Max.
+3.45
+70
REV D 102709
Units
V
C

Related parts for ics650-40