s29as016j Meet Spansion Inc., s29as016j Datasheet - Page 15

• Manufacturer Part Number: s29as016j
• Description: 16 Megabit 2 M X 8-bit/1 M X 16-bit Cmos 1.8 Volt-only Boot Sector Flash Memory
• Manufacturer: Meet Spansion Inc.

7.8
June 4, 2008 S29AS016J_00_04
Output Disable Mode
interrupted should be reinitiated once the device is ready to accept another command sequence, to ensure
data integrity.
Current is reduced for the duration of the RESET# pulse. When RESET# is held at V
draws CMOS standby current (I
will be greater.
The RESET# pin may be tied to the system reset circuitry. A system reset would thus also reset the Flash
memory, enabling the system to read the boot-up firmware from the Flash memory.
If RESET# is asserted during a program or erase operation, the RY/BY# pin remains a 0 (busy) until the
internal reset operation is complete, which requires a time of t
system can thus monitor RY/BY# to determine whether the reset operation is complete. If RESET# is
asserted when a program or erase operation is not executing (RY/BY# pin is 1), the reset operation is
completed within a time of t
RESET# pin returns to V
Refer to the tables in
for the timing diagram. If V
Temporary Sector Unprotect mode. See
feature.
When the OE# input is at V
impedance state.
D a t a
S h e e t
AC Characteristics on page 43
IH
( A d v a n c e
.
ID
READY
IH
(9.0 V – 11.0 V) is applied to the RESET# pin, the device will enter the
, output from the device is disabled. The output pins are placed in the high
CC4
(not during Embedded Algorithms). The system can read data t
). If RESET# is held at V
S29AS016J
Temporary Sector Unprotect on page 21
I n f o r m a t i o n )
for RESET# parameters and to
IL
READY
but not within V
(during Embedded Algorithms). The
SS
±0.2 V, the standby current
for more details on this
Figure 18.2 on page 44
SS
±0.2 V, the device
RH
after the
15