s29al016m Meet Spansion Inc., s29al016m Datasheet - Page 32

• Manufacturer Part Number: s29al016m
• Description: 16 Megabits 2m X 8-bits / 1m X 16-bits
• Manufacturer: Meet Spansion Inc.

30
Program Suspend/Program Resume Command Sequence
Notes:
1. See Tables
2. See
The Program Suspend command allows the system to interrupt a programming
operation so that data can be read from any non-suspended sector. When the
Program Suspend command is written during a programming process, the de-
vice halts the program operation within 15 μs maximum (5 μs typical) and
updates the status bits. Addresses are not required when writing the Program
Suspend command.
After the programming operation has been suspended, the system can read
array data from any non-suspended sector. The Program Suspend command
may also be issued during a programming operation while an erase is sus-
pended. In this case, data may be read from any addresses not in Erase
Suspend or Program Suspend. If a read is needed from the Secured Silicon Sec-
tor area (One-time Program area), then user must use the proper command
sequences to enter and exit this region.
The system may also write the autoselect command sequence when the device
is in the Program Suspend mode. The system can read as many autoselect
codes as required. When the device exits the autoselect mode, the device re-
verts to the Program Suspend mode, and is ready for another valid operation.
See Autoselect Command Sequence for more information.
After the Program Resume command is written, the device reverts to program-
ming. The system can determine the status of the program operation using the
“DQ3: Sector Erase Timer”
10–11
for erase command sequence.
No
Figure 5. Erase Operation
Command Sequence
Erasure Completed
from System
Write Erase
Data = FFh?
Data Poll
for more information.
START
S29AL016M
Yes
D a t a
S h e e t
Embedded
Erase
algorithm
in progress
S29AL016M_00_A7 October 11, 2006