nt39016d Newhaven Display International, Inc, nt39016d Datasheet - Page 9

• Manufacturer Part Number: nt39016d
• Description: One Chip Tft Lcd Driver Ic With Timing Controller For S960xg240 Tft Lcd
• Manufacturer: Newhaven Display International, Inc

Note:
I: Input, O: Output, P: Power, D: Dummy, S: Shorted line, M: Mark, PI: Power input, PO: Power output, T: Testing
I/ O: Input / Output. PS: Power Setting, C: Capacitor pin.
NT39016 Align Mark:
NT39016 Pass Line Description:
With respect to the information represented in this document, Novatek makes no warranty, expressed or implied, including the warranties of merchantability,
fitness for a particular purpose, non-infringement, or assumes any legal liability or responsibility for the accuracy, completeness, or usefulness of any such
information.
Pass Line No:
VCOMOUT
COM1_L/R
COM2_L/R
VPP_OTP
VCOMAC
ALIGN_T
ALIGN_B
Mar 10,2008
C1AP/M
Vint1/2
VCOM
C1P/M
C2P/M
C3P/M
C4P/M
DUM
GNDA
GNDP
VDDA
VDDP
FB_P
FB_N
VGH
GND
VGL
VDD
VCC
DRV
FB
1
2
M For assembly alignment.
M For assembly alignment.
PO
PS
PS
PS
PS
PI
PI
PI
PI
PI
VI
D
O
C
C
O
O
P
S
S
I
COM1_L
COM2_L
= 1.7V. Under the mode voltage can't control by 3-wire
Customer OTP power input pin
Capacitor pin. Positive power supply for Gate Driver output
Capacitor pin. Negative power supply for Gate Driver output
Capacitor pin. Power supply for VCOMOUT output
VCOM DC voltage output pin for DC re-construction
Frame polarity output for panel VCOM. Amplitude of signal is from GNDA1 to VDDA1
The polarity of VCOMOUT is inversed with internal signal “POL” when “FPOL” = 0
Power supply for source driver and gamma circuit
Ground pins for source driver and gamma circuit
Power supply for digital circuits
Ground pins for digital circuits
Power supply for charge pump circuits
Ground pins for charge pump circuits
Capacitor connect pin for internal regulator
Refer to the section of “Power Circuit” for the application.
Capacitor connect pin for internal charge pump
Refer to the section of “Power Circuit” for the application.
Internal power switch current input pad.
Note: Voltage on this pad should be < 5.5V. Pull low in more than one LED case.
Internal power switch current output pad.
Note: Voltage on this pad should be < 5.5V. Pull low in more than one LED case.
PWM controller feedback input. FB threshold is 0.6 V nominal
PWM output driver signal for the boost converter
The internal link together between input side and Output side.
The internal link together between input side and Output side.
Don’t connect to any signal or pull high/low.
Pad Name
COM1_R
COM2_R
9
Preliminary Spec. for NT39016D
TFT LCD Driver
Version 0.7