cs4341a Cirrus Logic, Inc., cs4341a Datasheet - Page 33

• Manufacturer Part Number: cs4341a
• Description: 24-bit, 192 Khz Stereo Dac With Volume Control
• Manufacturer: Cirrus Logic, Inc.

7.
Total Harmonic Distortion + Noise (THD+N)
Dynamic Range
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
8.
DS582F2
PARAMETER DEFINITIONS
REFERENCES
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.
The ratio of the full-scale rms value of the signal to the rms sum of all other spectral components over the
specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth
made with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement
to full scale. This technique ensures that the distortion components are below the noise level and do not
affect the measurement. This measurement technique has been accepted by the Audio Engineering So-
ciety, AES17-1991, and the Electronic Industries Association of Japan, EIAJ CP-307.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with all zeros to the input under test and a full-scale signal applied to the other channel. Units are
in decibels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal, full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
1) CDB4341A Evaluation Board Datasheet
2) “The I
http://www.semiconductors.philips.com
2
C Bus Specification: Version 2.1” Philips Semiconductors, January 2000.
CS4341A
33