S25FL128K Meet Spansion Inc., S25FL128K Datasheet - Page 43

• Manufacturer Part Number: S25FL128K
• Description: 128-mbit Cmos 3.0 Volt Flash Memory With 104-mhz Spi Serial Peripheral Interface Multi I/o Bus
• Manufacturer: Meet Spansion Inc.

April 1, 2011 S25FL128K_00_02
6.2.28
Read Manufacturer / Device ID Dual I/O (92h)
The Read Manufacturer / Device ID Dual I/O instruction is an alternative to the Read Manufacturer / Device
ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device ID at 2x speed.
The Read Manufacturer / Device ID Dual I/O instruction is similar to the Fast Read Dual I/O instruction. The
instruction is initiated by driving the CS# pin low and shifting the instruction code “92h” followed by a 24-bit
address (A23-A0) of 000000h, but with the capability to input the Address bits two bits per clock. After which,
the Manufacturer ID and the Device ID are shifted out 2 bits per clock on the falling edge of CLK with most
significant bits (MSB) first as shown in
Table 6.5, Device Identification on page
be read first and then followed by the Manufacturer ID. The Manufacturer and Device IDs can be read
continuously, alternating from one to the other. The instruction is completed by driving CS# high.
Note:
1. The “Continuous Read Mode” bits M(7-0) must be set to Fxh to be compatible with Fast Read Dual I/O instruction.
CLK
CLK
IO0
CS#
IO0
CS#
IO1
IO1
D a t a
S h e e t
Figure 6.34 Read Manufacturer / Device ID Dual I/O Diagram
( P r e l i m i n a r y )
Figure
S25FL128K
17. If the 24-bit address is initially set to 000001h the Device ID will
6.34. The Device ID values for the S25FL128K is listed in
43