nl10276bc24_13 NEC, nl10276bc24_13 Datasheet - Page 27

• Manufacturer Part Number: nl10276bc24_13
• Description: TFT COLOR LCD MODULE
• Manufacturer: NEC

6.3.2 Environment
6.3.3 Characteristics
6.3.4 Other
The following items are neither defects nor failures.
(VDDB) terminals should be used without a non-connected line.
recommends using the cloth with ethanolic liquid such as screen cleaner for LCD.
In order to prevent dew condensation occurring by temperature difference, the product packing box
must be opened after leave under the environment of an unpacking room temperature enough.
Because a situation of dew condensation occurring is changed by the environmental temperature
and humidity, evaluate the leaving time sufficiently. (Recommendation leaving time: 6 hour or more
with packing state)
patterns.
sequence may break down the product.
damage for high voltage side of the lamp. This damage may cause a lamp breaking and abnormal
operation of high voltage circuit.
gases. Keep the product in antistatic pouch in room temperature, because of avoidance for dusts
and sunlight, if customer stores the product.
This product is not designed as radiation hardened.
should be avoided, because it may change color or properties of the polarizer.
The LCD may be seemed luminance non-uniformity, flicker, vertical seam or small spot by display
depending on operating time, and especially low temperature, because the LCD has cold cathode
fluorescent lamps.
saver, if the fixed pattern is displayed on the screen.
backlight unit.
luminance control frequency of customer's backlight inverter may appear on a display. Set up
luminance control frequency of backlight inverter so that the interference noise does not appear.
backlight lamps.
Pay attention not to insert waste materials inside of products, if customer uses screwnails.
transportation, when customer returns it to NEC for repair and so on.
Do not operate in high magnetic field. Circuit boards may be broken down by it.
Use an original protection sheet on the product surface (polarizer). Adhesive type protection sheet
Response time, luminance and color may be changed by ambient temperature.
Do not display the fixed pattern for a long time because it may cause image sticking. Use a screen
The display color may be changed by viewing angle because of the use of condenser sheet in the
Optical characteristics may be changed by input signal timings.
All GND, backlight inverter ground (GNDB), VCC and backlight inverter power supply voltage
Do not disassemble a product or adjust variable resistors without permission of NEC.
See "REPLACEMENT MANUAL FOR LAMP HOLDER SET", if customer would like to replace
Do not press or rub on the sensitive display surface. If customer clean on the panel surface, NEC
Do not bend or unbend the lamp cable at the near part of the lamp holding rubber, to avoid the
Pack the product with original shipping package, because of avoidance of some damages during
Do not push-pull the interface connectors while the product is working, because wrong power
The interference noise of input signal frequency for this product's signal processing board and
Do not operate or store in high temperature, high humidity, dewdrop atmosphere or corrosive
Optical characteristics (e.g. luminance, display uniformity, etc.) gradually is going to change
DATA SHEET DOD-PD-0331 (2nd edition)
NL10276BC24-13
27