CLAA215FA01 CHUNGHWA PICTURE TUBES, CLAA215FA01 Datasheet - Page 28

• Manufacturer Part Number: CLAA215FA01
• Description: Display Module
• Manufacturer: CHUNGHWA PICTURE TUBES

www.DataSheet.co.kr
Title：CLAA215FA01
12. HANDLING PRECAUTIONS FOR TFT-LCD MODULE
ISO Datasheet No: T-3010004-008-F
Datasheet Version.: 01
1. ASSEMBLY PRECAUTION
Please pay attention to the followings in handling- TFT-LCD products;
(1) Please use the mounting hole on the module side in installing and do not beading or wrenching
(2) Please design display housing in accordance with the following guide lines.
(3) Please do not push or scratch LCD panel surface with any-thing hard. And do not soil LCD
(4) Please do not press any parts on the rear side such as source TCP, gate TCP, control circuit board
(5) Please wipe out LCD panel surface with absorbent cotton or soft cloth in case of it being soiled.
(6) Please wipe out drops of adhesives like saliva and water on LCD panel surface immediately.
(7) Please do not take a LCD module to pieces and reconstruct it. Resolving and reconstructing
(8) Please do not touch metal frames with bare hands and soiled gloves. A color change of the
LCD in assembling. And please do not drop, bend or twist LCD module in handling.
(2.1) Housing case must be destined carefully so as not to put stresses on LCD all sides and not to
(2.2) Keep sufficient clearance between LCD module back surface and housing when the LCD
(2.3) When some parts, such as, FPC cable and ferrite plate, are installed underneath the LCD
(2.4) Design the inverter location and connector position carefully so as not to give stress to lamp
(2.5) Keep sufficient clearance between LCD module and the others parts, such as inverter and
panel surface by touching with bare hands. (Polarizer film, surface of LCD panel is easy to be
flawed.)
and FPCs during handling LCD module. If pressing rear part is unavoidable, handle the LCD
module with care not to damage them.
They might damage to cause panel surface variation and color change.
modules may cause them not to work well.
metal frames can happen during a long preservation of soiled LCD modules.
wrench module. The stresses may cause non-uniformity even if there is no non-uniformity
statically.
module is mounted. Approximately 1.0 mm of the clearance in the design is recommended
taking into account the tolerance of LCD module thickness and mounting structure height
on the housing.
module, still sufficient clearance is required, such as 0.5mm. This clearance is, especially, to
be reconsidered when the additional parts are implemented for EMI countermeasure.
cable, or not to interface the LCD module by the lamp cable.
speaker so as not to interface the LCD module. Approximately 1.0mm of the clearance in
the design is recommended.
CHUNGHWA PICTUER TUBES, LTD.
CHUNGHWA PICTUER TUBES, LTD.
Technical Specification
TECHNICAL SPECIFICATION
Issue Date ：
Doc. No：
Version：
Page:
2008/12/30
28/31
A
Datasheet pdf - http://www.DataSheet4U.net/