LM3S8930 Luminary Micro, Inc, LM3S8930 Datasheet - Page 31

• Manufacturer Part Number: LM3S8930
• Description: Lm3s8930 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

1.4.3
1.4.3.1
1.4.3.2
July 25, 2008
On the LM3S8930, PWM motion control functionality can be achieved through:
■
CCP Pins (see page 208)
The General-Purpose Timer Module's CCP (Capture Compare PWM) pins are software programmable
to support a simple PWM mode with a software-programmable output inversion of the PWM signal.
Serial Communications Peripherals
The LM3S8930 controller supports both asynchronous and synchronous serial communications
with:
■
■
■
■
■
UART (see page 261)
A Universal Asynchronous Receiver/Transmitter (UART) is an integrated circuit used for RS-232C
serial communications, containing a transmitter (parallel-to-serial converter) and a receiver
(serial-to-parallel converter), each clocked separately.
The LM3S8930 controller includes one fully programmable 16C550-type UARTthat supports data
transfer speeds up to 3.125 Mbps. (Although similar in functionality to a 16C550 UART, it is not
register-compatible.) In addition, each UART is capable of supporting IrDA.
Separate 16x8 transmit (TX) and 16x12 receive (RX) FIFOs reduce CPU interrupt service loading.
The UART can generate individually masked interrupts from the RX, TX, modem status, and error
conditions. The module provides a single combined interrupt when any of the interrupts are asserted
and are unmasked.
SSI (see page 302)
Synchronous Serial Interface (SSI) is a four-wire bi-directional communications interface.
The LM3S8930 controller includes one SSI module that provides the functionality for synchronous
serial communications with peripheral devices, and can be configured to use the Freescale SPI,
MICROWIRE, or TI synchronous serial interface frame formats. The size of the data frame is also
configurable, and can be set between 4 and 16 bits, inclusive.
The SSI module performs serial-to-parallel conversion on data received from a peripheral device,
and parallel-to-serial conversion on data transmitted to a peripheral device. The TX and RX paths
are buffered with internal FIFOs, allowing up to eight 16-bit values to be stored independently.
The SSI module can be configured as either a master or slave device. As a slave device, the SSI
module can also be configured to disable its output, which allows a master device to be coupled
with multiple slave devices.
The SSI module also includes a programmable bit rate clock divider and prescaler to generate the
output serial clock derived from the SSI module's input clock. Bit rates are generated based on the
input clock and the maximum bit rate is determined by the connected peripheral.
The motion control features of the general-purpose timers using the CCP pins
One fully programmable 16C550-type UART
One SSI module
One I
Two CAN units
Ethernet controller
2
C module
Preliminary
LM3S8930 Microcontroller
31