UP018D02-1 DATAMODUL, UP018D02-1 Datasheet - Page 27

• Manufacturer Part Number: UP018D02-1
• Description: NTSC Color TFT
• Manufacturer: DATAMODUL

Incoming Inspection Standard
1.Scope
2.Incoming inspection:
3.Inspection sampling method:
4.Inspection instruments:
ALL RIGHTS STRICTLY RESERVED. ANY PORTION OF THIS PRPER SHALL NOT BE REPRODUCED, COPIED, OR
TRANSFORMED TO ANY OTHER FORMS WITHOUT PERMISSION FROM UNIPAC OPTOELECTRONICS CORP.
The incoming inspection standards shall be applied to TFT-LCD Modules
(hereinafter called "Modules") that supplied by Unipac Optoelectronics Corporation
(hereinafter called "seller").
The buyer(customer) shall inspect the modules within twenty calendar days of the
delivery date (the "inspection period") at its own cost. The results of the inspection
(acceptance or rejection) shall be recorded in writing, and a copy of this writing will
be promptly sent to the seller.
The buyer may, under commercially reasonable reject procedures, reject an entire lot
in the delivery involved if, within the inspection period,such samples of modules
within such lot show an unacceptable number of defects in accordance with this
incoming inspection standards, provided however that the buyer must notify the
seller in writing of any such rejection promptly, and not later than within three
business days of the end of the inspection period.
Should the buyer fail to notify the seller within the inspection period, the buyer's right
to reject the modules shall be lapsed and the modules shall be deemed to have been
accepted by the buyer.
Unless otherwise agree in writing, the method of incoming inspection shall be based
on MIL-STD-105E.
3-1. Lot size: Quantity per shipment lot per model.
3-2. Sampling type: Normal inspection, single sampling.
3-3. Sampling level: Level II.
3-4. Acceptable quality level (AQL):
4-1. A single 20W fluorescent lamp.
4-2. Pattern generator: Philips PM5518 or equivalent model.
4-3. Video board:Unipac video board or equivalent. The output of the signal should
4-4. Luminance colorimeter: Topcon BM-7 or equivalent model.
3-4-1. Major defect: AQL=0.4%.
3-4-2. Minor defect: AQL=1.5%.
comply with the specification provided by Unipac.
Spec. No.
Version
Page
: 413-212-091
: 1
:
25
/28