FDC37B77X SMSC Corporation, FDC37B77X Datasheet - Page 18

• Manufacturer Part Number: FDC37B77X
• Description: ENHANCED SUPER I/O CONTROLLER WITH WAKE UP FEATURES
• Manufacturer: SMSC Corporation

DIGITAL OUTPUT REGISTER (DOR)
Address 3F2 READ/WRITE
The DOR controls the drive select and motor
enables
BIT 0 and 1 DRIVE SELECT
These two bits are binary encoded for the drive
selects, thereby allowing only one drive to be
selected at one time.
BIT 2 nRESET
A logic "0" written to this bit resets the Floppy
disk controller.
until a logic "1" is written to this bit.
software reset does not affect the DSR and CCR
registers, nor does it affect the other bits of the
DOR register.
required is 100ns, therefore toggling this bit by
consecutive writes to this register is a valid
method of issuing a software reset.
BIT 3 DMAEN
PC/AT and Model 30 Mode:
Writing this bit to logic "1" will enable the DRQ,
nDACK, TC and FINTR outputs. This bit being
a logic "0" will disable the nDACK and TC
inputs, and hold the DRQ and FINTR outputs in
a high impedance state. This bit is a logic "0"
after a reset and in these modes.
PS/2 Mode: In this mode the DRQ, nDACK, TC
and FINTR pins are always enabled. During a
reset, the DRQ, nDACK, TC, and FINTR pins
will remain enabled, but this bit will be cleared to
a logic "0".
of
RESET
COND.
the
The minimum reset duration
This reset will remain active
disk
MOT
EN3
7
0
interface
MOT
EN2
6
0
outputs. It
MOT
EN1
5
0
This
MOT
EN0
18
4
0
also contains the enable for the DMA logic and a
software reset bit. The contents of the DOR are
unaffected by a software reset. The DOR can
be written to at any time.
BIT 4 MOTOR ENABLE 0
This bit controls the MTR0 disk interface output.
A logic "1" in this bit will cause the output pin to
go active.
BIT 5 MOTOR ENABLE 1
This bit controls the MTR1 disk interface output.
A logic "1" in this bit will cause the output pin to
go active.
BIT 6 MOTOR ENABLE 2
The MTR2 disk interface output is not supported
in the FDC37B77x.
BIT 7 MOTOR ENABLE 3
The MTR3 disk interface output is not supported
in the FDC37B77x.
DMAEN nRESE
3
0
Table 3 - Drive Activation Values
DRIVE
0
1
2
T
0
DRIVE
SEL1
1
0
DOR VALUE
DRIVE
SEL0
1CH
2DH
0
0