AT91RM9200DK ATMEL Corporation, AT91RM9200DK Datasheet - Page 16

• Manufacturer Part Number: AT91RM9200DK
• Description: AT91RM9200 Development Kit
• Manufacturer: ATMEL Corporation

DataSheet4U.com
www.DataSheet4U.com
DataSheet
Configuration Straps
4-2
6006A–ATARM–07/03
4
U
.com
Table 4-1. Configuration Straps and Jumper Settings
Designation
S16
S17
S18
S19
S20
S21
S22
S23
S24
S25
S26
S27
S28
S29
S30
S31
S32
S33
S34
S35
S36
S37
DataSheet4U.com
Default
Setting
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Feature
The PB13/TK2/ETX3 signal is connected to the SCLK
output signal of the Line Interface (MN23).
The PB15/RD2/ERX2 signal is connected to the SDO
output signal of the Line Interface (MN23).
Not Used: The Front End AC97 is not installed.
The PA30/DRXD/CTS2 signal is connected to the receive
buffer output of the DBGU transceiver (MN26).
The AT91RM9200's PC14 PIO line is connected to the
NREADY output signal of the Smart Card Interface (MN29).
The PA17/TXD0/TIOA0 is connected to the DATA
input/output signal of the Smart Card Interface (MN29).
The PA22/RXD2/TIOB2 is connected to the RX output
signal of the IrDA Transceiver (MN30).
Enables all output signals (DCD1, DSR1, RXD1, CTS1,
RI1) of the Transceiver (MN28) used for the RS232 Port
COM.
The PD4/ETXEN input line is connected to the USB device
socket (J28) to detect a host connection.
The System Reset signal (NRST) is connected to the
ICE/JTAG socket (J8, pin 15).
The NCS2 output signal is connected to the display
controller (MN32).
The NCS0 output signal is connected to the parallel Flash
memory (MN21).
Enables the OE signal from the Atmel FingerChip (MN31).
Only the socket is installed.
The SMCS/NCS3 output signal is connected to the
bidirectional buffer used by the Smart Media Connector
(MN20B).
The PA15/EMDC/TCLK2 output signal is connected to the
MDC input signal of the Ethernet Transceiver (MN22).
The PA16/EMDIO/IRQ6 input/output signal is connected to
the MDIO input/output signal of the Ethernet Transceiver
(MN22).
Disables the power-down mode of the Ethernet Transceiver
(MN22).
Not Used: The Front End AC97 is not installed.
Not Used: The Front End AC97 is not installed.
Not Used: The Front End AC97 is not installed.
Connects the system ground to the Ethernet ground.
Not Used: The Front End AC97 is not installed.
AT91RM9200 Development Kit User Guide