AT91RM9200DK ATMEL Corporation, AT91RM9200DK Datasheet - Page 15

• Manufacturer Part Number: AT91RM9200DK
• Description: AT91RM9200 Development Kit
• Manufacturer: ATMEL Corporation

DataSheet4U.com
www.DataSheet4U.com
DataSheet
4.1
AT91RM9200 Development Kit User Guide
4
U
.com
Configuration
Straps and
Jumper Settings
Table 4-1 gives details on configuration straps and jumper settings on the AT91RM9200
development board and their default settings.
Table 4-1. Configuration Straps and Jumper Settings
Designation
S10
S11
S12
S13
S14
S15
S1
S3
S4
S5
S6
S7
S8
S9
DataSheet4U.com
Opened
Opened
Default
Setting
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Closed
Feature
The earth plane and the GDN potential are connected.
The ETM reset (NSRST) and the System Reset (NRST) are
connected.
The PD6/DTXD PIO line is connected to the
READY/NBUSY output signal of the SPI DataFlash
(MN13).
The Write Protect feature of the SPI DataFlash (MN13) is
disabled.
The PA26/TWCK/IRQ1 signal is connected to three remote
devices (MN14, MN33, MN34).
The PA25/TWD/IRQ2 signal is connected to three remote
devices (MN14, MN33, MN34).
The PA3/NPCS0/IRQ5 output signal is not connected to the
NCS of the serial DataFlash (MN13).
The PA5/NPCS2/TXD3 signal is connected to the 10-bit SPI
ADC (MN15).
The PC15 I/O line is connected to the 10-bit ADC to read
the End Of Conversion event (MN15).
Not Used: The PS2 Controller is not installed.
Not Used: The PS2 Controller is not installed.
The PB12/TF2/ETX2 signal is connected to the
NRGDT/FSD output signal of the Line Interface (MN23).
The PB16/RK2/ERX2 signal is connected to the NOFHK
input signal of the Line Interface (MN23).
The PB17/RF2/ERXDV signal is connected to the NFSYN
input signal of the Line Interface (MN23).
Configuration Straps
Section 4
Rev. 6006A–ATARM–07/03
4-1