ADS1255IDB Burr-Brown Corporation, ADS1255IDB Datasheet - Page 35

• Manufacturer Part Number: ADS1255IDB
• Description: Very Low Noise/ 24-Bit Analog-to-Digital Converter
• Manufacturer: Burr-Brown Corporation

RDATAC: Read Data Continuous
Description: Issue command after DRDY goes low to enter the Read Data Continuous mode. This mode enables the
continuous output of new data on each DRDY without the need to issue subsequent read commands. After all 24 bits have
been read, DRDY goes high. It is not necessary to read back all 24 bits, but DRDY will then not return high until new data
is being updated. This mode may be terminated by the Stop Read Data Continuous command (STOPC). Because DIN
is constantly being monitored during the Read Data Continuous mode for the STOPC or RESET command, do not use
this mode if DIN and DOUT are connected together. See the Timing Characteristics for the required delay between the end
of the RDATAC command and the beginning of shifting data on DOUT: t
On the following DRDY, shift out data by applying SCLKs. The Read Data Continuous mode terminates if input_data equals
the STOPC or RESET command in any of the three bytes on DIN.
STOPC: Stop Read Data Continuous
Description: Ends the continuous data output mode. (see RDATAC). The command must be issued after DRDY goes low
and completed before DRDY goes high.
www.ti.com
Figure 31. DIN and DOUT Command Sequence During Read Continuous Mode
DRDY
DOUT
DIN
Figure 30. RDATAC Command Sequence
DRDY
DOUT
Figure 32. STOPC Command Sequence
DIN
0000 0011
DRDY
input_data
DIN
MSB
t
6
24 Bits
input_data
000 1111
Mid− Byte
input_data
6
LSB
.
24 Bits
SBAS288D − JUNE 2003 − REVISED AUGUST 2004
ADS1255
ADS1256
35