DF19G-14P-1HGND Hirose Electric, DF19G-14P-1HGND Datasheet - Page 12
![no-image](/images/no-image-200.jpg)
DF19G-14P-1HGND
Manufacturer Part Number
DF19G-14P-1HGND
Description
1 mm-Pitch Low Profile Connector System for Wire to PCB Applications Suitable for use with Discrete Wire, FPC or Fine Coaxial Cable12 pages, 862.55 KbOriginal
Manufacturer
Hirose Electric
Datasheet
1.DF19G-14P-1HGND.pdf
(12 pages)
12
B
Note1:The ground plate and the socket are sold separately.
Note2:Use the special tool for assembling.
Note3:To insert the ground plate, lift the FPC about 30° to make a space for insertion. Don’t apply excessive force (bending or
Note4:If the ground plate doesn’t enter the socket, don’t apply excessive force, but check whether it is parallel with the socket.
Note5:To protect the FPC, insert or pull out the connector in parallel with the engagement plane.
Note6:To protect the FPC, don’t apply excessive tension.
Note7:To bend the FPC, observe the allowable R and other conditions recommended by the manufacturer, and keep a distance
Note8:To assemble the FPC to the socket, use the recommended jigs and tools and be careful not to be injured by the
Assembly Procedure for FPC Socket
gouging, as the FPC copper foil (end of the cover film) will crack.
between the bending point and the socket as shown in the illustration below.
edge of the metallic part of the connector. Observe the instructions given in the manual for wiring jigs and tools.
The contents of this catalog are current as of May 2000 Contents are subject to change without notice for the purpose of improvements.