PS2832 NEC, PS2832 Datasheet - Page 7

• Manufacturer Part Number: PS2832
• Description: HIGH ISOLATION VOLTAGE HIGH COLLECTOR TO EMITTER VOLTAGE SOP MULTI OPTOCOUPLER
• Manufacturer: NEC

RECOMMENDED SOLDERING CONDITIONS
(1) Infrared reflow soldering
• Peak reflow temperature
• Time of temperature higher than 210 ˚C
• Number of reflows
• Flux
(2) Dip soldering
• Temperature
• Time
• Number of times
• Flux
(3) Cautions
• Fluxes
CAUTIONS REGARDING NOISE
start-up, the output side may enter the on state, even if the voltage is within the absolute maximum ratings.
Life Support Applications
These NEC products are not intended for use in life support devices, appliances, or systems where the malfunction of these products can reasonably be expected
to result in personal injury. The customers of CEL using or selling these products for use in such applications do so at their own risk and agree to fully indemnify
CEL for all damages resulting from such improper use or sale.
Be aware that when voltage is applied suddenly between the photocoupler's input and output or between corrector-emitters at
CALIFORNIA EASTERN LABORATORIES • Headquarters • 4590 Patrick Henry Drive • Santa Clara, CA 95054-1817 • [phone] • Telex 34-6393 • FAX [phone]
DATA SUBJECT TO CHANGE WITHOUT NOTICE
EXCLUSIVE NORTH AMERICAN AGENT FOR NEC RF, MICROWAVE & OPTOELECTRONIC SEMICONDUCTORS
100 to 160 ˚C
260 ˚C or below (molten solder temperature)
10 seconds or less
One
Rosin flux containing small amount of chlorine (The flux
with a maximum chlorine content of 0.2 Wt % is recommended).
Avoid removing the residual flux with chlorine-based cleaning solvent after a reflow process.
(preheating)
60 to 120 s
235 ˚C (package surface temperature)
30 seconds or less
Three
Rosin flux containing small amount of chlorine (The flux
with a maximum chlorine content of 0.2 Wt % is
recommended).
Time (s)
(heating)
to 10 s
to 30 s
235 ˚C (peak temperature)
210 ˚C
PS2832-1, -4, PS2833-1, -4
Internet: http://WWW.CEL.COM
01/24/2002