MAU200 Minmax Technology Co., Ltd., MAU200 Datasheet - Page 6

• Manufacturer Part Number: MAU200
• Description: 1w, High Isolation Sip, Single & Dual Output Dc/dc Converters
• Manufacturer: Minmax Technology Co., Ltd.

Test Configurations
Input Reflected-Ripple Current Test Setup
Lin (4.7uH) and Cin (220uF, ESR < 1.0[ at 100 KHz) to
simulate source impedance.
module, measurement bandwidth is 0-500 KHz.
Peak-to-Peak Output Noise Measurement Test
socket, measurement bandwidth is 0-20 MHz. Position the
load between 50 mm and 75 mm from the DC/DC Converter.
Design & Feature Considerations
Maximum Capacitive Load
capacitance at the output.
mode during start-up, affecting the ramp-up and the startup
time.
maximum capacitive load for dual outputs and 220
capacitive load for single outputs.
REV:0 2007/01
Input reflected-ripple current is measured with a inductor
Capacitor Cin, offsets possible battery impedance.
Current ripple is measured at the input terminals of the
Use a Cout 0.33uF ceramic capacitor.
Scope measurement should be made by using a BNC
The MAU200 series has limitation of maximum connected
The power module may be operated in current limiting
For optimum performance we recommend 100
The maximum capacitance can be found in the data sheet.
To Oscilloscope
+Vin
+
+Vin
Dual Output
-Vin
-Vin
Single Output
Battery
Converter
DC / DC
Converter
DC / DC
+
Cin
+Out
Com.
+Out
-Out
-Out
Lin
Current
Probe
Copper Strip
Copper Strip
Cout
Cout
Cout
+Vin
-Vin
Converter
DC / DC
+Out
-Out
Scope
Scope
Scope
Resistive
Resistive
Load
Load
Load
u
u
F
F
MINMAX
Input Source Impedance
ac-impedance input source. Highly inductive source
impedances can affect the stability of the power module.
output loading is high, it may be necessary to use a capacitor
at the input to ensure startup.
ensure stability of the unit, it is recommended to use a good
quality low Equivalent Series Resistance (ESR < 1.0[ at 100
KHz) capacitor of a 2.2uF for the 5V input devices, a 1.0uF for
the 12V input devices and a 0.47uF for the 24V devices.
Output Ripple Reduction
practicable across the load will give the best ripple and noise
performance.
capacitors at the output.
The power module should be connected to a low
In applications where power is supplied over long lines and
Capacitor mounted close to the power module helps
A good quality low ESR capacitor placed as close as
To reduce output ripple, it is recommended to use 1.0uF
DC Power
DC Power
DC Power
Source
Source
Source
+
+
-
-
+
-
MAU200 Series
+
Cin
+Vin
+Vin
-Vin
-Vin
+Vin
-Vin
Single Output
Dual Output
Converter
Converter
DC / DC
DC / DC
Converter
DC / DC
Com.
+Out
+Out
-Out
-Out
+Out
-Out
Cout
Load
Cout
Load
Load
6