WM8501 Wolfson Microelectronics plc, WM8501 Datasheet - Page 18

• Manufacturer Part Number: WM8501
• Description: 24-bit 192khz Stereo Dac With 1.7vrms Line Driver
• Manufacturer: Wolfson Microelectronics plc

WM8501
PCB LAYOUT RECOMMENDATIONS
w
Care should be taken in the layout of the PCB that the WM8501 is to be mounted to. The
following notes will help in this respect:
Further advice on this subject is available in WAN0129, available from
1.
2.
3.
4.
The VDD supply to the device should be as noise free as possible. This can be
accomplished to a large degree with a 10uF bulk capacitor placed locally to the device and a
0.1uF high frequency decoupling capacitor placed as close to the VDD pin as possible. It is
best to place the 0.1uF capacitor directly between the VDD and GND pins of the device on
the same layer to minimize track inductance and thus improve device decoupling
effectiveness.
The VMID pin should be as noise free as possible. This pin provides the decoupling for
the on chip reference circuits and thus any noise present on this pin will be directly coupled
to the device outputs. In a similar manner to the VDD decoupling described above, this pin
should be decoupled with a 10uF bulk capacitor local to the device and a 0.1uF capacitor as
close to the VMID pin as possible.
Separate analogue and digital track routing from each other. The device is split into
analogue (pins 5 – 9) and digital (pins 1 – 4 and pins 10 – 14) sections that allow the routing
of these signals to be easily separated. By physically separating analogue and digital
signals, crosstalk from the PCB can be minimized.
Use an unbroken solid GND plane.
advisable to have either a GND plane layer on a multilayer PCB or to dedicate one side of a
2 layer PCB to be a GND plane. For double sided implementations it is best to route as
many signals as possible on the device mounted side of the board, with the opposite side
acting as a GND plane. The use of a GND plane greatly reduces any electrical emissions
from the PCB and minimizes crosstalk between signals.
To achieve best performance from the device, it is
www.wolfsonmicro.com
PD, Rev 4.2, July 2009
Production Data
18