CS61574-IL Cirrus Logic, Inc., CS61574-IL Datasheet - Page 18

• Manufacturer Part Number: CS61574-IL
• Description: Interface, T1/E1 Line Interface
• Manufacturer: Cirrus Logic, Inc.

the register. In either mode, a reset will set all reg-
isters to 0 and force the oscillator to its center
frequency before initiating calibration. A reset
will also set LOS high.
Power Supply
The device operates from a single +5 Volt supply.
Separate pins for transmit and receive supplies
provide internal isolation. These pins should be
connected externally near the device and decou-
pled to their respective grounds. TV+ must not
exceed RV+ by more than 0.3V.
Decoupling and filtering of the power supplies is
crucial for the proper operation of the analog cir-
cuits in both the transmit and receive paths. A 1.0
and TGND, and a 0.1 F capacitor should be con-
nected between RV+ and RGND. Use mylar or
ceramic capacitors and place them as closely as
possible to their respective power supply pins. A
68 F tantalum capacitor should be added close
to the RV+/RGND supply. Wire-wrap bread-
boarding of the line interface is not recommended
because lead resistance and inductance serve to
defeat the function of the decoupling capacitors.
18
F capacitor should be connected between TV+
Schematic & Layout Review Service
C a l l : ( 5 1 2 ) 4 4 5 - 7 2 2 2
Confirm Optimum
Schematic & Layout
Before Building Your Board.
For Our Free Review Service
Call Applications Engineering.
CS61577
DS155PP2