ST7MC2M9 STMicroelectronics, ST7MC2M9 Datasheet - Page 98

• Manufacturer Part Number: ST7MC2M9
• Description: 8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC,BRUSHLESS MOTOR CONTROL, 5 TIMERS, SPI, LINSCI(TM)
• Manufacturer: STMicroelectronics

Specifications of ST7MC2M9

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators and by-pass for external clock, clock security system.
• Four Power Saving Modes: Halt, Active-Halt, Wait and Slow
• Main Clock Controller With: Real time base, Beep and Clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, external clock input, PWM and pulse generator modes
• 8-bit Pwm Auto-reload Timer With: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector

As an alternative to using the SS pin to control the
Slave Select signal, the application can choose to
manage the Slave Select signal by software. This
is configured by the SSM bit in the SPICSR regis-
ter (see
In software management, the external SS pin is
free for other application uses and the internal SS
signal level is driven by writing to the SSI bit in the
SPICSR register.
98/309
1
– SS internal must be held high continuously
Figure
(if CPHA = 0)
(if CPHA = 1)
MOSI/MISO
Master SS
Slave SS
Slave SS
58).
SS external pin
SSI bit
(cont’d)
Byte 1
SSM bit
1
0
There are two cases depending on the data/clock
timing relationship (see
If CPHA = 1 (data latched on second clock edge):
If CPHA = 0 (data latched on first clock edge):
– SS internal must be held low during the entire
– SS internal must be held low during byte
Byte 2
SS internal
transmission. This implies that in single slave
applications the SS pin either can be tied to
V
ing the SS function by software (SSM = 1 and
SSI = 0 in the in the SPICSR register)
transmission and pulled high between each
byte to allow the slave to write to the shift reg-
ister. If SS is not pulled high, a Write Collision
error will occur when the slave writes to the
shift register (see
SS
, or made free for standard I/O by manag-
Byte 3
Section
Figure
10.4.5.3).
57):