STM8AF6166 STMicroelectronics, STM8AF6166 Datasheet - Page 22

• Manufacturer Part Number: STM8AF6166
• Description: Automotive 8-bit MCU, with up to 128 Kbytes Flash, EEPROM, 10-bit ADC, timers, LIN, CAN, USART, SPI, I2C, 3 V to 5.5 V
• Manufacturer: STMicroelectronics

Specifications of STM8AF6166

• Max Fcpu: 16 MHz
• Flash Program Memory: 16 to 32 Kbytes Flash; data retention 20 years at 55 °C after 1 kcycle
• Data Memory: 0.5 to 1 Kbyte true data EEPROM; endurance 300 kcycles
• Ram: 1 to 2 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

Product overview
5.9.3
22/91
●
Universal asynchronous receiver/transmitter with LIN support
(LINUART)
The devices covered by this datasheet contain one LINUART interface. The interface is
available on all the supported packages. The LINUART is an asynchronous serial
communication interface which supports extensive LIN functions tailored for LIN slave
applications. In LIN mode it is compliant to the LIN standards rev 1.2 to rev 2.1.
Detailed feature list:
LIN mode
Master mode:
●
●
Slave mode:
●
●
●
●
●
●
UART mode
●
●
●
●
●
●
●
●
●
–
–
–
Wakeup from Halt on address detection in slave mode
LIN break and delimiter generation
LIN break and delimiter detection with separate flag and interrupt source for read back
checking.
Autonomous header handling – one single interrupt per valid header
Mute mode to filter responses
Identifier parity error checking
LIN automatic resynchronization, allowing operation with internal RC oscillator (HSI)
clock source
Break detection at any time, even during a byte reception
Header errors detection:
–
–
–
–
–
Full duplex, asynchronous communications - NRZ standard format (mark/space)
High-precision baud rate generator
–
Programmable data word length (8 or 9 bits) – 1 or 2 stop bits – parity control
Separate enable bits for transmitter and receiver
Error detection flags
Reduced power consumption mode
Multi-processor communication - enter mute mode if address match does not occur
Wakeup from mute mode (by idle line detection or address mark detection)
Two receiver wakeup modes:
Successful address/data communication
Error condition
Wakeup from Halt
Delimiter too short
Synch field error
Deviation error (if automatic resynchronization is enabled)
Framing error in synch field or identifier field
Header time-out
A common programmable transmit and receive baud rates up to f
Doc ID 14952 Rev 5
STM8AF61xx, STM8AF62xx
MASTER
/16