LPC11U13FBD48 NXP Semiconductors, LPC11U13FBD48 Datasheet - Page 2

• Manufacturer Part Number: LPC11U13FBD48
• Description: The LPC11U13FBD48 is a ARM Cortex-M0 based, low-cost 32-bit MCU, designed for 8/16-bit microcontroller applications, offering performance, low power, simple instruction set and memory addressing together with reduced code size compared to existing 8/
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC11U1X
Product data sheet









Analog peripherals:
Serial interfaces:
Clock generation:
Power control:
Unique device serial number for identification.
Single 3.3 V power supply (1.8 V to 3.6 V).
Temperature range 40 C to +85 C.
Available as LQFP48, TFBGA48, and HVQFN33 packages.
Pin compatible to the LPC134x series.























Two GPIO grouped interrupt modules enable an interrupt based on a
programmable pattern of input states of a group of GPIO pins.
High-current source output driver (20 mA) on one pin (P0_7).
High-current sink driver (20 mA) on true open-drain pins (P0_4 and P0_5).
Four general purpose counter/timers with a total of up to 5 capture inputs and 13
match outputs.
Programmable Windowed WatchDog Timer (WWDT) with a dedicated, internal
low-power WatchDog Oscillator (WDO).
10-bit ADC with input multiplexing among eight pins.
USB 2.0 full-speed device controller.
USART with fractional baud rate generation, internal FIFO, a full modem control
handshake interface, and support for RS-485/9-bit mode and synchronous mode.
USART supports an asynchronous smart card interface (ISO 7816-3).
Two SSP controllers with FIFO and multi-protocol capabilities.
I
a data rate of up to 1 Mbit/s with multiple address recognition and monitor mode.
Crystal Oscillator with an operating range of 1 MHz to 25 MHz (system oscillator).
12 MHz high-frequency Internal RC oscillator (IRC) that can optionally be used as
a system clock.
Internal low-power, low-frequency WatchDog Oscillator (WDO) with programmable
frequency output.
PLL allows CPU operation up to the maximum CPU rate with the system oscillator
or the IRC as clock sources.
A second, dedicated PLL is provided for USB.
Clock output function with divider that can reflect the crystal oscillator, the main
clock, the IRC, or the watchdog oscillator.
Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deep
power-down.
Power profiles residing in boot ROM allow optimized performance and minimized
power consumption for any given application through one simple function call.
Processor wake-up from Deep-sleep and Power-down modes via reset, selectable
GPIO pins, watchdog interrupt, or USB port activity.
Processor wake-up from Deep power-down mode using one special function pin.
Integrated PMU (Power Management Unit) to minimize power consumption during
Sleep, Deep-sleep, Power-down, and Deep power-down modes.
Power-On Reset (POR).
Brownout detect with four separate thresholds for interrupt and forced reset.
2
C-bus interface supporting the full I
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 11 January 2012
2
C-bus specification and Fast-mode Plus with
32-bit ARM Cortex-M0 microcontroller
LPC11U1x
© NXP B.V. 2012. All rights reserved.
2 of 69