TDA7407DTR STMicroelectronics, TDA7407DTR Datasheet - Page 32

• Manufacturer Part Number: TDA7407DTR
• Description: IC PROCESSOR ADV SIGNAL 44-LQFP
• Manufacturer: STMicroelectronics
• Type: Car Signal Processorr

Specifications of TDA7407DTR

• Applications: Automotive Systems
• Mounting Type: Surface Mount
• Package / Case: 44-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Multipath detector
5.4.1
5.4.2
5.4.3
5.5
32/46
Figure 24. Block diagram of the multipath detector
Programming
To obtain a good multipath performance an adaptation is necessary. Therefore the gain of
the 19kHz bandpass is programmable in four steps as well as the rectifier gain. The attack
and decay times can be set by the external capacitor value.
Quality detector
The TDA7407 offers a quality detector output which gives a voltage representing the FM
reception conditions. To calculate this voltage the MPX noise and the multipath detector
output are summed according to the following formula:
The noise signal is the PEAK signal without additional influences. The factor "a" can be
programmed from 0.7 to 1.15. the output is a low impedance output able to drive external
circuitry as well as simply fed to an A/D converter for RDS applications.
AF Search Control
The TDA7407 is supplied with several functionality to support AF checks using the stereo
decoder. As mentioned already before the high ohmic mute feature avoids any clicks during
the jump condition. It is possible at the same time, to evaluate the noise and multipath
content of the alternate frequency, by using the quality detector output. Therefore the
multipath detector is switched automatically to a small time constant. No additional pin
(AFS) is implemented in order to separate the audioprocessor mute and stereo decoder AF
functions. In
functionality is shown (please note that the pins AFS and SM are active low as well as all
control bits indicated by an overbar).
Test mode
During the test mode, which can be activated by setting bit D0 of the testing byte and bit D5
of the subaddress byte to "1", several internal signals are available at the CASSR pin.
During this mode the input resistor of 100kOhm is disconnected from the pin. The internal
signals available are shown in the software specification.
Figure 25
Quality = 1.6 (V
the block diagram and control functions of the complete AFS
noise
-0.8V)+ a (REF5V - V
MPOUT
)
TDA7407