E-TDA7409DTR STMicroelectronics, E-TDA7409DTR Datasheet - Page 8

• Manufacturer Part Number: E-TDA7409DTR
• Description: IC PROCESSOR CAR SIGNAL 20SOIC
• Manufacturer: STMicroelectronics
• Type: Car Signal Processorr

Specifications of E-TDA7409DTR

• Applications: Automotive Systems
• Mounting Type: Surface Mount
• Package / Case: 20-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

TDA7409
1.2 AutoZero
In order to reduce the number of pins there is no AC coupling between the In-Gain and the following stage, so
that any offset generated by or before the In-Gain-stage would be transferred or even amplified to the output.
To avoid that effect a special Offset-cancellation-stage called AutoZero is implemented. This stage is located
before the Mixing-block to eliminate all offsets generated by the Input-Stages and the In-Gain (Please notice
that externally generated offsets, e.g. generated through the leakage current of the coupling capacitors, are not
canceled).
The auto-zeroing is started every time the DATA-BYTE 0 (Input Selector/Gain) is selected and takes a time of
max. 0.3ms. To avoid audible clicks the Audioprocessor is muted before the loudness stage during this time.
1.2.1 AutoZero-Remain
In some cases, for example if the uP is executing a refresh cycle of the IIC-Bus-programming, it is not useful
to start a new AutoZero-action because no new source is selected and an undesired mute would appear at the
outputs. For such applications the TDA7409 could be switched in the AutoZero-Remain-Mode (I2 bit of the
subaddress-byte). If this bit is set to high, the DATABYTE 0 could be loaded without invoking the AutoZero and
the old adjustment-value remains.
1.3 Mixing Stage
The 4 step Mixing stage offers the possibility to mix the rear selector signal or the phone signal to any other
source. Due to the fact that the mixing-stage is located behind the In-Gain-stage fine adjustments of the main
source level could be done in this way.
Figure 2. Signal-Flow of Mixing-Stage
1.4 Loudness
There are four parameters programmable in the loudness stage:
1.4.1 Attenuation
Figure 3 shows the attenuation as a function of frequency at f
8/25
BEEP
SE1
SE2
SE3
SE4
INPUT SELECTOR
INGAIN
+
-
25K
C
INPUT
-3.5dB
-12dB
MIXING LEVEL
= 400Hz.
-6dB
0dB
D00AU1181
/
/
/
/
/
-100dB
-9.6dB
-2.5dB
BEEP
-6dB
MIXING
LOUDNESS