SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 39

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

10.14 Pulse Width Modulation Controller (PWM)
10.15 Soft Modem (SMD)
11053AS–ATARM–27-Jul-11
• 4 channels, one 32-bit counter per channel
• Common clock generator, providing Thirteen Different Clocks
• Independent channel programming
• Modulations and protocols
• Data compression and error correction
• Type I Caller ID (CID) decoding
• Sixty-three embedded and upgradeable country profiles
• Embedded AT commands
• SmartDAA
– A Modulo n counter providing eleven clocks
– Two independent Linear Dividers working on modulo n counter outputs
– Independent Enable Disable Commands
– Independent Clock Selection
– Independent Period and Duty Cycle, with Double Bufferization
– Programmable selection of the output waveform polarity
– Programmable center or left aligned output waveform
– V.90
– V.34
– V.32bis, V.32, V.22bis, V.22, V.23, V.21
– V.23 reverse, V.23 half-duplex
– Bell 212A/Bell 103
– V.29 FastPOS
– V.22bis fast connect
– V.80 Synchronous Access Mode
– V.44 data compression (V.92 model)
– V.42bis and MNP 5 data compression
– V.42 LAPM and MNP 2-4 error correction
– EIA/TIA 578 Class 1 and T.31 Class 1.0
– Call Waiting (CW) detection and Type II Caller ID decoding during data mode
– Extension pick-up detection
– Digital line protection
– Line reversal detection
– Line-in-use detection
– Remote hang-up detection
– Worldwide compliance
SAM9G35
39