SAM7L128 Atmel Corporation, SAM7L128 Datasheet - Page 136

• Manufacturer Part Number: SAM7L128
• Manufacturer: Atmel Corporation

Specifications of SAM7L128

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 36 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 80
• Ext Interrupts: 80
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Segment Lcd: 40
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 460
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 6
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.8 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Debug Interface
5-14
The EmbeddedICE Logic comprises:
•
•
•
The debug control register and the debug status register provide overall control of
EmbeddedICE operation.
You can program one or both watchpoint units to halt the execution of instructions by
the core. Execution halts when the values programmed into EmbeddedICE match the
values currently appearing on the address bus, data bus, and various control signals.
You can mask any bit so that its value does not affect the comparison.
You can configure each watchpoint unit for either a watchpoint or a breakpoint.
Watchpoints and breakpoints can be data-dependent.
two real-time watchpoint units
two independent registers:
—
—
Debug Communications Channel (DCC).
Note
Copyright © 1994-2001. All rights reserved.
the debug control register
debug status register.
ARM DDI 0029G