SAM7L128 Atmel Corporation, SAM7L128 Datasheet - Page 114

• Manufacturer Part Number: SAM7L128
• Manufacturer: Atmel Corporation

Specifications of SAM7L128

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 36 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 80
• Ext Interrupts: 80
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Segment Lcd: 40
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 460
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 6
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.8 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Coprocessor Interface
4.4.6
4.4.7
4-10
Execute stage
Decode stage
coprocessor)
coprocessor)
Fetch stage
(from ARM)
Coprocessor data operations
Coprocessor load and store operations
CPA (from
CPB (from
D[31:0]
MCLK
nCPI
Coprocessor data operations, CDP instructions, perform processing operations on the
data held in the coprocessor register bank. No information is transferred between the
ARM7TDMI processor and the coprocessor as a result of this operation. An example
sequence is shown in Figure 4-3.
The coprocessor load and store instructions are used to transfer data between a
coprocessor and memory. They can be used to transfer either a single word of data, or
a number of the coprocessor registers. There is no limit to the number of words of data
that can be transferred by a single LDC or STC instruction, but by convention no more
than 16 words should be transferred in a single instruction. An example sequence is
shown in Figure 4-4 on page 4-11.
If you transfer more than 16 words of data in a single instruction, the worst case
interrupt latency of the ARM7TDMI processor increases.
ADD
Instr fetch
(ADD)
Note
Copyright © 1994-2001. All rights reserved.
ADD
SUB
Instr fetch
(SUB)
MCR
SUB
ADD
Instr fetch
(MCR)
Figure 4-3 Coprocessor data operation sequence
MCR
SUB
TST
Instr fetch
(TST)
MCR
SUB
TST
Instr fetch
(SUB)
SUB
TST
Instr fetch
ARM DDI 0029G
SUB