RM9200 Atmel Corporation, RM9200 Datasheet - Page 28

• Manufacturer Part Number: RM9200
• Manufacturer: Atmel Corporation

Specifications of RM9200

• Flash (kbytes): 0 Kbytes
• Pin Count: 256
• Max. Operating Frequency: 180 MHz
• Cpu: ARM920
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 122
• Ext Interrupts: 122
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 1
• Twi (i2c): 1
• Uart: 5
• Ssc: 3
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

10.6
10.7
28
SDRAM Controller
Burst Flash Controller
AT91RM9200
• Multiple Wait State Management
• Numerous configurations supported
• Programming facilities
• Energy-saving capabilities
• Error detection
• SDRAM Power-up Initialization by software
• Latency is set to two clocks (CAS Latency of 1, 3 Not Supported)
• Auto Precharge Command not used
• Multiple Access Modes supported
• Adaptability to different device speed grades
• Adaptability to different device access protocols and bus interfaces
– Compliant with LCD Module
– Programmable Setup Time Read/Write
– Programmable Hold Time Read/Write
– Programmable Wait State Generation
– External Wait Request
– Programmable Data Float Time
– 2K, 4K, 8K Row Address Memory Parts
– SDRAM with two or four Internal Banks
– SDRAM with 16- or 32-bit Data Path
– Word, half-word, byte access
– Automatic page break when Memory Boundary has been reached
– Multibank Ping-pong Access
– Timing parameters specified by software
– Automatic refresh operation, refresh rate is programmable
– Self-refresh and Low-power Modes supported
– Refresh Error Interrupt
– Asynchronous or Burst Mode Byte, Half-word or Word Read Accesses
– Asynchronous Mode Half-word Write Accesses
– Programmable Burst Flash Clock Rate
– Programmable Data Access Time
– Programmable Latency after Output Enable
– Two Burst Read Protocols: Clock Control Address Advance or Signal Controlled
– Multiplexed or separate address and data buses
– Continuous Burst and Page Mode Accesses supported
Address Advance
1768MS–ATARM–09-Jul-09