ATmega644R212 Atmel Corporation, ATmega644R212 Datasheet - Page 22
ATmega644R212
Manufacturer Part Number
ATmega644R212
Description
Manufacturer
Atmel Corporation
Specifications of ATmega644R212
Flash (kbytes)
64 Kbytes
Max. Operating Frequency
20 MHz
Max I/o Pins
32
Spi
3
Twi (i2c)
1
Uart
1
Adc Channels
8
Adc Resolution (bits)
10
Adc Speed (ksps)
15
Analog Comparators
1
Crypto Engine
AES
Sram (kbytes)
4
Eeprom (bytes)
2048
Operating Voltage (vcc)
1.8 to 3.6
Timers
3
Frequency Band
700/800/900MHz
Max Data Rate (mb/s)
1
Antenna Diversity
No
External Pa Control
Yes
Power Output (dbm)
10
Receiver Sensitivity (dbm)
-110
Receive Current Consumption (ma)
9.0
Transmit Current Consumption (ma)
18 at 5dBm
Link Budget (dbm)
120
- Current page: 22 of 198
- Download datasheet (5Mb)
Figure 6-10. Example SPI Sequence - Frame Buffer Write of a Frame with 4 byte PSDU
6.2.3
Figure 6-11. Packet Structure - SRAM Read Access
8111C–MCU Wireless–09/09
/SEL
SCLK
MOSI
MISO
MOSI
MISO
0
SRAM Access Mode
byte 1 (command byte)
0
PHY_STATUS
0
PHY_STATUS
COMMAND
reserved[4:0]
Access violations during a Frame Buffer read or write access are indicated by interrupt IRQ_6
(TRX_UR). For further details, refer to
Notes
The SRAM access mode allows accessing dedicated bytes within the Frame Buffer. This may
reduce the SPI traffic.
The SRAM access mode is useful, for instance, if a transmit frame is already stored in the Frame
Buffer and dedicated bytes (e.g. sequence number, address field) need to be replaced before
retransmitting the frame. Furthermore, it can be used to access only the LQI value after frame
reception. A detailed description of the user accessible frame content can be found in
9.3 “Frame Buffer” on page
Each SRAM access starts with /SEL = L. The first transferred byte on MOSI shall be the com-
mand byte and must indicate an SRAM access mode according to the definition in
page
space is 0x00 to 0x7F for radio transceiver receive or transmit operations.
On SRAM read access, one or more bytes of read data are transferred on MISO starting with the
third byte of the access sequence (see
• The Frame Buffer is shared between RX and TX; therefore, the frame data are overwritten by
• To avoid overwriting during receive Dynamic Frame Buffer Protection can be enabled, refer to
• It is not possible to retransmit received frames without a Frame Buffer read and write access
• For exceptions, e.g. receiving acknowledgement frames in Extended Operating Mode
new incoming frames. If the TX frame data are to be retransmitted, it must be ensured that no
frame was received in the meanwhile.
Section 11.8 “Dynamic Frame Buffer Protection” on page
cycle.
(TX_ARET) refer to
CSMA-CA Retry” on page
0
19. The following byte indicates the start address of the write or read access. The address
XX
PHR
ADDRESS[6:0]
byte 2 (address)
XX
PSDU 1
XX
Section 7.2.4 “TX_ARET_ON - Transmit with Automatic Retry and
107.
byte 3 (data byte)
64.
DATA[7:0]
XX
PSDU 2
XX
Section 9.3 “Frame Buffer” on page
Figure 6-11 on page
PSDU 3
XX
byte n-1 (data byte)
DATA[7:0]
22).
154.
XX
PSDU 4
XX
AT86RF231
107.
byte n (data byte)
DATA[7:0]
XX
Table 6-2 on
Section
22
Related parts for ATmega644R212
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Manufacturer:
Atmel Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet: