ISD5216SY Nuvoton Technology Corporation of America, ISD5216SY Datasheet - Page 12

• Manufacturer Part Number: ISD5216SY
• Description: IC VOICE REC/PLAY 8-16MIN 28SOIC
• Manufacturer: Nuvoton Technology Corporation of America
• Series: ISL5216r

Specifications of ISD5216SY

• Interface: I²C
• Filter Pass Band: 1.8 ~ 3.7kHz
• Duration: 8 ~ 16 Min
• Mounting Type: Surface Mount
• Package / Case: 28-SOIC (0.300", 7.50mm Width)
• For Use With: ISD-ES511 - EVALUATION SYSTEM FOR ISD5100ISD-ES501 - EVALUATION SYSTEM FOR ISD5008
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ISD5216
The following diagram shows the functional blocks in the CODEC:
7.2.1. Analog Input to Digital Output Path
A 200 kHz anti-aliasing filter processes the analog input signal before entering the amplifier for the
A/D converter. The gain of this amplifier is adjustable through the configuration registers bits (CIG2 –
CIG0) for a gain from 0.80 to 2.00.
The Sigma Delta modulator is a Linear 14 bit ΣΔ modulator running at a sampling frequency
determined by the external clock input and the internal clock dividers (CKD2, CKDV). The standard
telecom frequency of 8kHz and digital audio of 44.1kHz and 48 kHz as well as intermediate
frequencies as shown in the table on the next page are supported. The A/D converter can be turned
off to save power and reduce noise by setting the A/D power down bit (ADPD).
The A/D converter feeds a 3.4 kHz digital anti aliasing filter which can be muted to suppress noise, the
mute bit controls both the A/D and D/A filter simultaneously. The following high pass filter is enabled
by bit (HPF0) in the configuration register. The High Sampling Rate bit (HSR0) needs to be set to
enable operation at 44.1kHz – 48 kHz.
The digital audio signal can be companded using μ - Law and A-Law companding or go to the output
uncompressed using 2’s complement or signed magnitude output selected with bits (LAW1 – LAW0)
in the configuration registers.
2
Finally the digital output interface is selected to be either full-duplex PCM or half duplex I
S using the
2
interface selector bit (I
S0) in the configuration register. The PCM interface uses the SDIO and SDI
2
pins, the half-duplex I
S format uses the SDIO pin as both input and output.
- 12 -