LPC1820FET100,551 NXP Semiconductors, LPC1820FET100,551 Datasheet - Page 38
LPC1820FET100,551
Manufacturer Part Number
LPC1820FET100,551
Description
IC MCU 32BIT 136KB FLSH 100TFBGA
Manufacturer
NXP Semiconductors
Series
LPC18xxr
Datasheets
1.LPC1830FET256551.pdf
(87 pages)
2.LPC1810FET100551.pdf
(2 pages)
3.LPC1810FET100551.pdf
(1164 pages)
Specifications of LPC1820FET100,551
Core Processor
ARM® Cortex-M3™
Core Size
32-Bit
Speed
150MHz
Connectivity
CAN, EBI/EMI, I²C, Microwire, SPI, SSI, SSP, UART/USART, USB OTG
Peripherals
Brown-out Detect/Reset, DMA, I²S, Motor Control PWM, POR, PWM, WDT
Number Of I /o
64
Program Memory Size
-
Program Memory Type
ROMless
Eeprom Size
-
Ram Size
168K x 8
Voltage - Supply (vcc/vdd)
2 V ~ 3.6 V
Data Converters
A/D 12x10b; D/A 1x10b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
100-TFBGA
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
NXP Semiconductors
LPC1850_30_20_10
Objective data sheet
7.12.1.1 Features
7.12.1 State Configurable Timer (SCT) subsystem
7.12.2 General Purpose DMA (GPDMA)
7.12 AHB peripherals
The SCT allows a wide variety of timing, counting, output modulation, and input capture
operations. The inputs and outputs of the SCT are shared with the capture and match
inputs/outputs of the 32-bit general purpose counter/timers.
The SCT can be configured as two 16-bit counters or a unified 32-bit counter. In the
two-counter case, in addition to the counter value the following operational elements are
independent for each half:
In the two-counter case, the following operational elements are global to the SCT, but the
last three can use match conditions from either counter:
The DMA controller allows peripheral-to memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. Each DMA stream
provides unidirectional serial DMA transfers for a single source and destination. For
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
State variable
Limit, halt, stop, and start conditions
Values of Match/Capture registers, plus reload or capture control values
Clock selection
Inputs
Events
Outputs
Interrupts
Two 16-bit counters or one 32-bit counter.
Counter(s) clocked by bus clock or selected input.
Up counter(s) or up-down counter(s).
State variable allows sequencing across multiple counter cycles.
Event combines input or output condition and/or counter match in a specified state.
Events control outputs and interrupts.
Selected event(s) can limit, halt, start, or stop a counter.
Supports:
– up to 8 inputs (one input connected internally)
– up to 16 outputs
– 16 match/capture registers
– 16 events
– 32 states
All information provided in this document is subject to legal disclaimers.
Rev. 1.2 — 17 February 2011
32-bit ARM Cortex-M3 microcontroller
LPC1850/30/20/10
© NXP B.V. 2011. All rights reserved.
38 of 87