F10-S30R Omron, F10-S30R Datasheet - Page 17

• Manufacturer Part Number: F10-S30R
• Description: 25C4243
• Manufacturer: Omron

Specifications of F10-S30R

• Sensing Range: 90mm To 110mm
• Peak Reflow Compatible (260 C): No
• Terminal Type: Wire Leaded
• Supply Current Max: 150mA
• Supply Voltage Max: 19.8VDC
• Sensor Terminals: Cable
• Leaded Process Compatible: No
• Rohs Compliant: No

F10
Troubleshooting
24
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
Buzzer
sounds
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
Problem
This LED of the threshold
indicators flashes and the
buzzer sounds.
This LED of the threshold
indicators flashes and the
buzzer sounds.
This LED of the threshold
indicators flashes and the
buzzer sounds.
This LED of the threshold
indicators flashes and the
buzzer sounds.
This LED of the threshold
indicators flashes and the
buzzer sounds.
This LED of the threshold
indicators flashes and the
buzzer sounds.
All the LEDs of the
threshold indicators flash
and the buzzer sounds
three times.
Head disconnection error
The Head is not connected properly and no
image signal is obtainable.
Hardware error
A hardware failure, such as CPU runaway,
has resulted.
Head data read error
1.The EEPROM data of the Head is not
2.The data is illegal.
Amplifier data read error
1.The EEPROM data of the Amplifier is not
2.The data is illegal.
Amplifier data write error
1.No EEPROM data is written to the
2.The data is illegal.
Head type error
An F10-S30/S15 is connected to the head.
Teaching data setting error
The Sensor was set to MONITOR or RUN
mode before teaching completed.
readable.
readable.
Amplifier.
Probable cause
Connect the Head and turn the Sensor
OFF and ON.
Note:
Consult your OMRON representative.
Turn the Sensor OFF and ON.
Note:
Note:
Connect an F10-S30R/S15R/S05R to the
head.
Perform the teaching of the Sensor in
TEACH mode.
If the same error occurs again, the
Head may be broken. Consult your
OMRON representative.
All internal data of the Amplifier may
be cleared.
If the same error occurs again after
turning the Sensor OFF and ON,
consult your OMRON representa-
tive.
Refer to 1. Pattern Registration
(TEACH Mode) on page 19.
Remedy
F10