AM29LV128MH123REI Spansion Inc., AM29LV128MH123REI Datasheet - Page 32

• Manufacturer Part Number: AM29LV128MH123REI
• Manufacturer: Spansion Inc.

Specifications of AM29LV128MH123REI

• Cell Type: NOR
• Density: 128Mb
• Access Time (max): 120ns
• Interface Type: Parallel
• Boot Type: Not Required
• Address Bus: 24/23Bit
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: -40C to 85C
• Package Type: TSOP
• Program/erase Volt (typ): 3/11.5 to 12.5V
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8/16Bit
• Number Of Words: 16M/8M
• Supply Current: 43mA
• Mounting: Surface Mount
• Pin Count: 56
• Lead Free Status / Rohs Status: Not Compliant

32
DQ1 = 1?
No
Yes
(Note 3)
(Note 1)
Yes
(Note 2)
No
Write next address/data pair
Write number of addresses
to program minus 1(WC)
Write first address/data
Write program buffer to
address = Last Loaded
Write “Write to Buffer”
Read DQ7 - DQ0 with
Last Loaded Address
flash sector address
and Sector Address
Read DQ7 - DQ0 at
Buffer Operation?
Sector Address
FAIL or ABORT
command and
WC = WC - 1
Abort Write to
DQ7 = Data?
DQ7 = Data?
Figure 4. Write Buffer Programming Operation
DQ5 = 1?
Address
WC = 0 ?
No
Yes
No
No
No
D A T A
Yes
Yes
Yes
Am29LV128MH/L
S H E E T
Part of “Write to Buffer”
Command Sequence
Write to buffer ABORTED.
Must write “Write-to-buffer
Abort Reset” command
Write to a different
sequence to return
sector address
to read mode.
PASS
Notes:
1.
2. DQ7 may change simultaneously with DQ5.
3. If this flowchart location was reached because
4.
When Sector Address is specified, any address in
the selected sector is acceptable. However, when
loading Write-Buffer address locations with data, all
addresses must fall within the selected Write-Buffer
Page.
Therefore, DQ7 should be verified.
DQ5= “1”, then the device FAILED. If this flowchart
location was reached because DQ1= “1”, then the
Write to Buffer operation was ABORTED. In either
case, the proper reset command must be written
before the device can begin another operation. If
DQ1=1, write the
Write-Buffer-Programming-Abort-Reset
command. if DQ5=1, write the Reset command.
See
required for write buffer programming.
Table 10
and
Table 11
25270C7 January 31, 2007
for command sequences