ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 6

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

To assemble this flat lens and holder, observe the following brief procedure.
1. Place the lens into the inside of the cap, ensuring that the grooves of the lens are facing
2. Place the cap over the base, ensuring that the top of the lens is toward the arrow on the
3. Place the lens and lens holder assembly onto the ZMOTION Development Board with
4. Fasten each of the four (4) provided
QS007801-0411
inward.
base. Use the provided ¾" machine screws (2) with a nut to secure the cap in place, as
shown in Figure 5.
the arrow on the lens holder pointing up, as shown in Figure 5; use the Primary Place-
ment position labeled on the circuit board for the WA 1.2 GI 12 V4 lens. The four screw
holes in the circuit board should line up with the four upper mounting holes in the lens
holder.
holder in place. Figure 6 shows an example of the top of the lens holder installed on the
ZMOTION Development Board.
Figure 5. Assembled Flat 1.2" Lens Holder and Flat Lens
ZMOTION
⅜
" machine screws with a nut to secure the lens
™
Intrusion Detection Development Kit
Quick Start Guide
Page 6 of 9