ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 4

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

2. Insert the power supply output connector into the Mini-USB Plug P1 on the ZMOTION
3. The Blue power LED will illuminate and the Red LED will initially illuminate and re-
4. To test this procedure, wave your hand over the lens and notice the LED turning ON
For more information about the operation of the kit, including how to download and debug
your own ZMOTION project, please refer to the ZMOTION Intrusion Detection Kit User
Manual (UM0233), included on the Application and Documentation CD and available
from
Installing the Lens
Flat Lens Holder
The flat lens holder, shown in Figure 3, is a two-piece assembly that provides a 1.2" focal
length mounting. Figure 4 shows the detail of the WA 1.2 GI 12 V4 lens, with its correct
orientation.
QS007801-0411
Note:
Note:
Development Board and insert the other end into the wall outlet. Move SW1 on the
board up to the ON position.
main on until the pyroelectric sensor stabilizes
onds. After the PIR sensor has stabilized, the Red LED turns OFF, to turn ON only
when motion is detected.
for approximately 1 second.
the Zilog
Please use the power supply provided with the kit.
When mounting the ZMOTION Development Board vertically, special con-
sideration should be taken regarding the height, angle and level plane of the
board. Be sure to follow the lens manufacturer’s recommended height and
mounting angle requirements to ensure optimal performance.
website.
ZMOTION
™
–
Intrusion Detection Development Kit
a period of approximately 5 to 30 sec-
Quick Start Guide
Page 4 of 9