A5975ADTR STMicroelectronics, A5975ADTR Datasheet - Page 14

• Manufacturer Part Number: A5975ADTR
• Description: IC REG SW STEP-DOWN 2.5A 8SOIC
• Manufacturer: STMicroelectronics
• Series: -r
• Type: Step-Down (Buck), PWMr

Specifications of A5975ADTR

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 1.235 V ~ 35 V
• Current - Output: 2.5A
• Frequency - Switching: 500kHz
• Voltage - Input: 4 V ~ 36 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (0.154", 3.90mm Width) Exposed Pad
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-11425-2

Functional description
Figure 6.
5.4
14/50
Synchronization example
Current protection
The A5975AD features two types of current limit protection; pulse-by-pulse and frequency
foldback.
The schematic of the current limitation circuitry for the pulse-by-pulse protection is shown in
Figure
The smallest one includes a resistor in series, R
R
switched off until the next falling edge of the internal clock pulse. Due to this reduction of the
ON time, the output voltage decreases. As the minimum switch-on time necessary to sense
the current in order to avoid a false overcurrent signal is too short to obtain a sufficiently low
duty cycle at 500 kHz (see
circuit conditions may not be properly limited. For this reason, the switching frequency is
also reduced, therefore keeping the inductor current under its maximum threshold. The
frequency shifter
voltage decreases (due to the reduced duty cycle), the switching frequency decreases also.
SENSE
7. The output power PDMOS transistor is split into two parallel PDMOS transistors.
and, if it reaches the threshold, the mirror becomes unbalanced and the PDMOS is
(Figure
5) functions based on the feedback voltage. As the feedback
Section
Doc ID 018761 Rev 1
8.5), the output current in strong overcurrent or short-
SENSE
. The current is sensed through
A5975AD