TDA9850 NXP Semiconductors, TDA9850 Datasheet - Page 8

• Manufacturer Part Number: TDA9850
• Manufacturer: NXP Semiconductors

Specifications of TDA9850

• Lead Free Status / Rohs Status: Compliant

Philips Semiconductors
Adjustment procedure
C
Feed in from FM demodulator the composite signal with
100% modulation (25 kHz deviation) L + R; f
Set input level control via I
OUTR (500 mV 20 mV). Store the setting in a
non-volatile memory.
A
1995 Jun 19
UTOMATIC ADJUSTMENT PROCEDURE
OMPOSITE INPUT LEVEL ADJUSTMENT
Connect 2.2 F capacitors from ACR and ACL to
ground.
Composite input signal L = 300 Hz, R = 3.1 kHz,
14% modulation for each channel.
Mode selection setting bits: STEREO = 1, SAP = 0
(see Table 8).
Start adjustment by transmission ADJ = 1 in register
ALI3. The decoder will align itself.
After 1 second minimum stop alignment by transmitting
ADJ = 0 in register ALI3 read the alignment data by an
I
(see Chapter “I
non-volatile memory. The alignment procedure
overwrites the previous data stored in ALI1 and ALI2.
The capacitors from ACR and ACL may be
disconnected after alignment.
I
2
2
C-bus read operation from ALR1 and ALR2
C-bus controlled BTSC stereo/SAP decoder
2
C-bus protocol”) and store it in a
2
C-bus monitoring OUTL or
i
= 300 Hz.
8
M
Manual adjustment is necessary when no dual tone
generator is available (e.g. for service).
After every power-on, the alignment data and the input
level adjustment data must be loaded from the non-volatile
memory.
T
Due to possible internal and external spreading, the timing
current can be adjusted via I
recommended by dbx.
IMING CURRENT FOR RELEASE RATE
ANUAL ADJUSTMENT
Spectral and wideband data have to be set to 10000
(middle position for adjustment range)
Composite input L = 300 Hz; 14% modulation
Adjust channel separation by varying wideband data
Composite input L = 3 kHz; 14% modulation
Adjust channel separation by varying spectral data
Iterative spectral/wideband operation for optimum
adjustment
Store data in non-volatile memory.
2
C-bus, see Table 9, as
Preliminary specification
TDA9850