STEVAL-ILL022V1 STMicroelectronics, STEVAL-ILL022V1 Datasheet - Page 4

• Manufacturer Part Number: STEVAL-ILL022V1
• Description: BOARD & REF DESIGN
• Manufacturer: STMicroelectronics
• Series: -r

Specifications of STEVAL-ILL022V1

• Design Resources: STEVAL-ILL022V1 Schematic STEVAL-ILL022V1 BOM
• Main Purpose: Reference Design, Solar Charger, LED Driver
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: STM32F101R
• Primary Attributes: 25W LED Driver, 80W Battery Charger
• Secondary Attributes: Automatic day/night/weather detection, automatic battery/mains switch over
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Safety instructions
1
1.1
1.2
1.3
1.4
4/18
Safety instructions
Intended use
The demonstration board is a component designed for demonstration purposes only, and
shall not be used for domestic or industrial installations. The technical data and information
concerning the power supply and working conditions must be taken from the documentation
provided with the delivery, and must be strictly observed.
Installation
The installation instructions of the demonstration board must be taken from the present
document and strictly observed. The components must be protected against excessive
strain. In particular, no components are to be bent, or isolating distances altered, during the
transportation, handling or use. The demonstration board contains electro-statically
sensitive components that are prone to damage through improper use. Electrical
components must not be mechanically damaged or destroyed (to avoid potential risks and
health injury).
Electrical connection
Applicable national accident prevention rules must be followed when working on the mains
power supply. The electrical installation must be completed in accordance with the
appropriate requirements (e.g. cross-sectional areas of conductors, fusing and PE
connections).
Board operation
A system architecture that supplies power to the demonstration board must be equipped
with additional control and protective devices in accordance with the applicable safety
requirements (e.g. compliance with technical equipment and accident prevention rules).
Warning:
The demonstration board must be used in a suitable
laboratory by qualified personnel only, familiar with the
installation, use and maintenance of electrical systems.
Doc ID 14469 Rev 2
UM0512