DP110-TRANSLUCENT-400ML 3M, DP110-TRANSLUCENT-400ML Datasheet - Page 6

• Manufacturer Part Number: DP110-TRANSLUCENT-400ML
• Description: Chemicals 400ML EXPOXY TRANSLUCENT
• Manufacturer: 3M

Specifications of DP110-TRANSLUCENT-400ML

• Product: Adhesives
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 02120087847 62356335307 DP110

Surface Preparation
3M
Epoxy Adhesives
DP110 Translucent and Gray
Application Equipment
Suggestions
™
Scotch-Weld
These products may be applied by spatula, trowel or flow equipment.
Two part mixing/proportioning/dispensing equipment is available for intermittent or
production line use. These systems are ideal because of their variable shot size and
flow rate characteristics and are adaptable to many applications.
For high strength structural bonds, paint, oxide films, oils, dust, mold release agents
and all other surface contaminants must be completely removed from substrate to be
bonded. However, the amount of surface preparation necessary directly depends on
the user’s required bond strength, environmental aging resistance and economic
practicalities.
The following cleaning methods are suggested for common surfaces:
Steel:
1. Wipe free of dust with oil-free solvent such as acetone or isopropyl alcohol
2. Sandblast or abrade using clean fine grit abrasives.
3. Wipe again with solvent to remove loose particles.*
4. If a primer is used, it should be applied within 4 hours after surface preparation.
Aluminum:
1. Alkaline Degrease: Oakite 164 solution (9-11 oz./gallon water) at 190°F ± 10°F
2. Acid Etch: Place panels in the following solution for 10 minutes at 150°F ± 5°F
3. Rinse: Rinse panels in clear running tap water.
4. Dry: Air dry 15 minutes; force dry 10 minutes at 150°F ± 10°F (66°C ± 23°C).
5. If primer is to be used, it should be applied within 4 hours after surface preparation.
Plastics/Rubber:
1. Wipe with isopropyl alcohol.*
2. Abrade using fine grit abrasives.
3. Wipe with isopropyl alcohol.*
*Note: When using solvents, extinguish all ignition sources, including pilot lights,
solvents.*
(88°C ± 23°C) for 10-20 minutes. Rinse immediately in large quantities of cold
running water.
(66°C ± 23°C).
™
and follow the manufacturer’s precautions and directions for use.
Sodium Dichromate
Sulfuric Acid, 66°Be
2024-T3 aluminum (dissolved)
Tap water as needed to balance
- 6 -
4.1 - 4.9 oz./gallon
38.5 o 41.5 oz./gallon
0.2 oz./gallon minimum