DP110-TRANSLUCENT-400ML 3M, DP110-TRANSLUCENT-400ML Datasheet - Page 5

• Manufacturer Part Number: DP110-TRANSLUCENT-400ML
• Description: Chemicals 400ML EXPOXY TRANSLUCENT
• Manufacturer: 3M

Specifications of DP110-TRANSLUCENT-400ML

• Product: Adhesives
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 02120087847 62356335307 DP110

3M
Epoxy Adhesives
DP110 Translucent and Gray
Handling/Curing
Information
™
Scotch-Weld
Directions for Use
1. For high strength structural bonds, paint, oxide films, oils, dust, mold release
2. These products consist of two parts.
3. For maximum bond strength apply product evenly to both surfaces to be joined.
4. Application to the substrates should be made within 8 minutes. Larger quantities
5. Join the adhesive coated surfaces and allow to cure at 60°F (16°C) or above until
6. Keep parts from moving during cure. Contact pressure necessary. Maximum shear
7. Excess uncured adhesive can be cleaned up with ketone type solvents.*
*Note: When using solvents, extinguish all ignition sources, including pilot lights,
Adhesive Coverage: A 0.005 in. thick bondline will typically yield a coverage of
™
agents and all other surface contaminants must be completely removed from
substrates to be bonded. However, the amount of surface preparation necessary
directly depends on the user’s required bond strength, environmental aging
resistance and economic practicalities. For specific surface preparations on
common substrates, see the section on surface preparation.
and/or higher temperatures will reduce this working time.
completely firm. Heat up to 200°F (93°C), will speed curing. These products will
fully cure in 48 hours @ 75°F (24°C).
strength is obtained with a 3-5 mil bond line.
Mixing
For Duo-Pak Cartridges
3M™ Scotch-Weld™ Epoxy Adhesive DP110 Translucent and Gray are
supplied in a dual syringe plastic duo-pak cartridge as part of the 3M™ EPX™
Applicator system. To use, simply insert the duo-pak cartridge into the EPX
applicator and start the plunger into the cylinders using light pressure on the
trigger. Next, remove the duo-pak cartridge cap and expel a small amount of
adhesive to be sure both sides of the duo-pak cartridge are flowing evenly and
freely. If automatic mixing of Part A and Part B is desired, attach the EPX
mixing nozzle to the duo-pak cartridge and begin dispensing the adhesive. For
hand mixing, expel the desired amount of adhesive and mix thoroughly. Mix
approximately 15 seconds after a uniform color is obtained.
For Bulk Containers
Mix thoroughly by weight or volume in the proportions specified on the product
label or in the uncured properties section. Mix approximately 15 seconds after a
uniform color is obtained.
and follow the manufacturer’s precautions and directions for use.
320 sq. ft./gallon.
- 5 -