L6728H STMicroelectronics, L6728H Datasheet - Page 14

Voltage Mode PWM Controllers Sgl Output 300 KHz DFN-10

L6728H

Manufacturer Part Number
L6728H
Description
Voltage Mode PWM Controllers Sgl Output 300 KHz DFN-10
Manufacturer
STMicroelectronics
Datasheet

Specifications of L6728H

Number Of Outputs
Single Output
Switching Frequency
300 KHz
Operating Supply Voltage
5 V to 12 V
Supply Current
6 mA
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 40 C
Package / Case
DFN-10
Mounting Style
SMD/SMT
Lead Free Status / Rohs Status
Lead free / RoHS Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
L6728HTR
Manufacturer:
ST
0
Output voltage setting and protections
9
14/32
Output voltage setting and protections
L6728H is capable to precisely regulate an output voltage as low as 0.8 V. In fact, the device
comes with a fixed 0.8 V internal reference that guarantee the output regulated voltage to be
within ±0.8% tolerance over line and temperature variations (excluding output resistor
divider tolerance, when present).
Output voltage higher than 0.8 V can be easily achieved by adding a resistor R
FB pin and ground. Referring to
where V
L6728H monitors the voltage at VSEN pin and compares it to internal reference voltage in
order to provide under voltage and over voltage protections as well as PGOOD signal.
According to the level of VSEN, different actions are performed from the controller:
PGOOD
If the voltage monitored through VSEN exits from the PGOOD window limits, the device
de-asserts the PGOOD signal still continuing switching and regulating. PGOOD is
asserted at the end of the soft-start phase.
Under voltage protection
If the voltage at VSEN pin drops below UV threshold, the device turns off both HS and
LS MOSFETs, latching the condition. Cycle VCC to recover.
Over voltage protection
If the voltage at VSEN pin rises over OV threshold (1 V typ), over voltage protection
turns off HS MOSFET and turns on LS MOSFET. The LS MOSFET will be turned off as
soon as VSEN goes below Vref/2 (0.4 V). The condition is latched, cycle VCC to
recover. Notice that, even if the device is latched, the device still controls the LS
MOSFET and can switch it on whenever VSEN rises above OV threshold.
Feedback disconnection protection
In order to provide load protection even if VSEN pin is not connected, a 100 nA bias
current is always sourced from this pin. If VSEN pin is not connected, this current will
permanently pull it up causing the device to detect an OV: thus LS will be latched on
preventing output voltage from rising out of control.
REF
is 0.8 V.
V
Doc ID 15725 Rev 1
OUT
Figure
=
1, the steady state DC output voltage will be:
V
REF
1
+
---------- -
R
R
OS
FB
OS
between
L6728H

Related parts for L6728H