TD340ID STMicroelectronics, TD340ID Datasheet - Page 13

• Manufacturer Part Number: TD340ID
• Description: MOSFET & Power Driver ICs H-Bridge Quad MOSFET
• Manufacturer: STMicroelectronics
• Type: High Side/Low Sider

Specifications of TD340ID

• Supply Voltage (min): 6.5 V
• Supply Current: 7 mA
• Maximum Power Dissipation: 500 mW
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Package / Case: SO-20
• Bridge Type: H Bridge
• Minimum Operating Temperature: - 40 C
• Number Of Drivers: 4
• Number Of Outputs: 4
• Output Current: 1.5 A
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

TD340
Watchdog circuit
An integrated Watchdog circuit resets the microcontroller when a periodic signal coming from the
microcontroller is missing after an externally adjustable Time out delay.
Watchdog timeout is adjustable by means of a capacitor Cwd between CWD pin and GND. This capacitor
should be placed as close as possible to the CWD pin.
Watchdog function can be inhibited by tying the CWD pin to ground.
Timeout range is from about 1ms to 1s, approximate value is given by:
Twd = 1 + (20 x Cwd)
(Twd in ms, and Cwd in nF).
When the watchdog timeout triggers, the reset output is pulsed once low for 20 microseconds, and the
driver outputs are set to ground (MOS switched off). TD340 stays in disable state (MOS off) until pulses
appear again on WD pin.
Figure 7 : Watchdog waveforms
t
treset
tw d
t
tipw
t
Temperature output
The TD340 provides a temperature indicator with the TEMP output.
TEMP voltage is 2.68V at 25 C with a temperature coefficient of -7.5mV/ C.
The goal of this function is to provide a rough temperature indication to the uP. It allows the system
designer to adapt the behavior of the application to the ambient temperature.
The TEMP output must be connected to a high impedance input. Maximum available current is 1uA.
13/21