G310C000 Red Lion Controls, G310C000 Datasheet - Page 7

• Manufacturer Part Number: G310C000
• Description: OPERATOR INTERFACE; COLOR TFT LCD; 10 INCH; 24V; 8MB FLASH MEMORY
• Manufacturer: Red Lion Controls
• Type: Color Graphicr

Specifications of G310C000

• Dimensions: 12.83 W × 9.5 H In.
• Display Size: 10 In.
• Memory: 8 Mb Flash
• Mounting Type: Panel
• Primary Type: Operator Interface
• Resolution: 640 × 480 Pixel LCD
• Resolution, Display: 640 × 480
• Size: 10 In. Color TFT
• User Interface: Touchscreen
• Voltage, Supply: 24 V
• Lead Free Status / Rohs Status: RoHS Compliant part

BATTERY & TIME KEEPING
accuracy of the G310 time keeping is less than one minute per month drift. The
battery of a G310 unit does not affect the unit’s memory, all configurations and
data is stored in non-volatile memory.
cover of the unit. To remove the cover, remove the five screws designated by the
arrows on the rear of the unit. Then, by lifting the top side, hinge the cover, thus
providing clearance for the connectors on the bottom side of the PCB as shown
in the illustration below. Install in the reverse manner.
Replace the rear cover, cables, and re-apply power. Using Crimson or the unit’s
keypad, enter the correct time and date.
complies with your local waste regulations. Also, the battery must not be
disposed of in fire, or in a manner whereby it may be damaged and its contents
come into contact with human skin.
A battery is used to keep time when the unit is without power. Typical
To change the battery of a G310, remove power, cabling, and then the rear
Remove the old battery* from the holder and replace with the new battery.
* Please note that the old battery must be disposed of in a manner that
The battery used by the G310 is a lithium type CR2025.
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT
EQUIPMENT UNLESS POWER HAS BEEN DISCONNECTED
AND THE AREA IS KNOWN TO BE NON-HAZARDOUS.
WARNING - EXPLOSION HAZARD - THE AREA MUST BE
KNOWN TO BE NON-HAZARDOUS BEFORE SERVICING/
REPLACING THE UNIT AND BEFORE INSTALLING OR
REMOVING I/O WIRING AND BATTERY.
CAUTION: The circuit board contains static sensitive
components. Before handling the operator interface without
the rear cover attached, discharge static charges from your
body by touching a grounded bare metal object. Ideally,
handle the operator interface at a static controlled clean
workstation. Also, do not touch the surface areas of the
circuit board. Dirt, oil, or other contaminants may adversely
affect circuit operation.
CAUTION: RISK OF ELECTRIC SHOCK
The inverter board, attached to the mounting plate, supplies
the high voltage to operate the backlight. Touching the
inverter board may result in injury to personnel.
7
G310C
G310S