STBVP6-RB1E02 BANNER ENGINEERING, STBVP6-RB1E02 Datasheet - Page 9

• Manufacturer Part Number: STBVP6-RB1E02
• Description: Safety; Duo-Touch; Run Bar System; LED Indicator; 2 NC Safety Contacts
• Manufacturer: BANNER ENGINEERING

Specifications of STBVP6-RB1E02

• Function: Proximity
• Primary Type: Photoelectric
• Sensing Mode: Through-Beam
• Technology: Photoelectric

If all of the described checks cannot be
verified, the two-hand control system
must not be used until the problem
has been corrected. Injury or death to
personnel may result from attempts to use
the machine under such conditions.
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
WARNING. . .
Not Use System
Until Checkouts Are
Verified
Do
Checkout procedures are dependent on what two-hand control system or module is
interfaced with the DUO-TOUCH Run Bar. At minimum, the procedure should include the
requirements on page 4 and the following:
1. Verify that all point-of-operation guards are in place and operating properly.
2. Verify that the two actuating devices must be simultaneously engaged to actuate the
3. For single-cycle machines: Verify that maintained engagement of the two actuating
4. For part-revolution clutch machines: Verify that release of either actuating device
5. Verify that the distance from each actuating device to the closest hazard point is not
Checkout procedures should be accomplished at installation (i.e., commissioning) and at
periodic intervals, such as:
* Qualified person: A person who, by possession of a recognized degree or certificate
NOTE: Do not attempt any repairs to the STB Series touch buttons. They contain no
If it ever becomes necessary to return an STB Series touch button to the factory, please
do the following:
1. Contact the Banner Factory Application Engineering Group at the address or at the
2. Pack the components carefully. Damage which occurs in return shipping is not covered
of professional training, or who, by extensive knowledge, training, and experience,
has successfully demonstrated the ability to solve problems relating to the installation,
maintenance and use of the Two-Hand Control System.
— Daily Checkout, to be performed at every power-up, shift change, and machine
— Semi-Annual Checkout, to be performed at six-month intervals. This semi-annual
machine (within ½ second).
devices results in only one machine cycle.
results in the immediate arrest of the machine motion.
closer than the calculated safety distance (see page 6).
numbers listed at the bottom of the back page. They will attempt to troubleshoot the
system from your description of the problem. If they conclude that a component is
defective, they will issue an RMA (Return Merchandise Authorization) number for your
paperwork, and give you the proper shipping address.
by warranty.
setup change, and to be performed by a designated person, appointed and
identified in writing by the employer.
checkout must be performed by a qualified person.* A copy of test results should be
kept on or near the machine.
DUO-TOUCH
field-replaceable components. Return them to the factory for warranty repair
or replacement.
Checkout Procedures
®
Run Bar with STB Buttons
Repairs
P/N 131634 rev. B
9